Zyxel P-793H specifications

P-793H

G.SHDSL.bis 4-port Security Gateway

Quick Start Guide

Version 3.40

Edition 1

6/2006

Copyright © 2006 ZyXEL Communications Corporation. All rights reserved.

P-793H Quick Start Guide

Overview

You can use the P-793H to set up high-speed Internet access or point-to­point connections. This Quick Start Guide explains how to set up the P-793H
for Internet access. Please see the User’s Guide for information about
setting up point-to-point connections.

1 Hardware Connections

1 Use a telephone wire to connect the P-793H’s DSL port to the telephone

jack or wall outlet.

2 Use an Ethernet cable to connect a computer to a LAN port for Internet

access or to configure the P-793H.

3 Use the power adaptor provided with your P-793H to connect an

appropriate power source to the POWER socket. Make sure the power
source is on.

4 Push in the POWER button. Look at the lights on the front panel.

•The POWER light blinks green while your P-793H starts up and stays on
once it is ready.

2

P-793H Quick Start Guide

•The DSL1 and DSL2 lights blink while the P-793H is looking for the ISP and
stay on if the P-793H finds it.

• Each LAN light stays on if the corresponding LAN port is properly con­nected and blinks when there is traffic.

If any of these lights are off, check your connections, and inspect your
cables for damage. If the lights are still off, contact your local vendor.

2 Status Page

1 Open your Internet browser,

and enter http://192.168.1.1. If
you do not see the screen
below, see Troubleshooting.

2 Enter the password user to go directly to the Status screen.

3