Zte WF720 User Manual

WF720

In The Box

1. WF720 Wireless Home Phone Base Station

2. Phone Cable

3. Back-up Battery

4. Power Adapter

5. Quick Start Guide

Getting to Know Your Device

Power

Green: On
No Color: Off

Voicemail

Green: New message
waiting (Blinking)

No Color: No message
waiting

Battery Charge

Green: High
Yellow: Medium
Red: Low

Power Button
On/Off

Telephone Ports

Service Port*

1 2

Signal Strength

Green: Strong
Yellow: Weak
Red: No Service

Power Port

Battery Cover

Antenna Port

Before You Begin

Your device works exclusively with your wireless service

providers’ cellular network and DOES NOT use your home’s

phone wall jacks.

Your device should be located:



Where you have a strong cellular signal from a cell tower,

typically near a window or outside wall.



Near an electrical wall outlet.

Install the SIM Card and the Battery

1. Remove the cover from the battery compartment.

2. Insert the SIM card in the SIM card slot.

3. Insert the battery connection cable into the battery port.

4. Place the battery in the battery slot and replace the battery

cover.

1 2

3 4

43

Connect the Device to a Phone

1. Unplug your phone from your home’s phone wall jack.

2. Plug your phone into the “Phone 1” port on the WF720,

using your existing phone cable or included phone cable.

NOTE: Put the device at least 2.5 meters away from the con-

nected phone, TV sets, radio and other electronic devices to

avoid electromagnetic interference.

DECT (Digital Enhanced Cordless Telecommunications)

Phone: To avoid electromagnetic interference between DECT

phone and the device, be sure the distance between DECT

phone and the device is 0.5 meter at least.

5 6

Turn on Your Device

1. Plug the power adapter into an electrical wall outlet.

2. Insert the small end of the power adapter into the Power

port on the back of your device.

3. Press and hold the power button about 8 seconds until the

signal strength light comes on.

Check the Wireless Signal

1. Raise antenna to an upright position.

2. Conrmsignal strength light is green for optimal perfor-

mance.

7 8

Make a Call

Make a call from your connected home phone.

NOTE: If you have a cordless phone, keep it plugged into a

power outlet.

PIN Lock

Refer to the following table to check your SIM card status, and

perform the corresponding action.

SIM Status Light Indicator Action

Signal indictor: No

PIN Locked

PUK locked

SIM card

permanently

locked

NOTE: When you enter wrong PIN code for 3 times, the SIM

card will be PUK locked; When you enter wrong PUK code for

10 times, the SIM card will be permanently locked.

colour;

Battery Indicator:

Green blinking

Signal indictor: No

colour;

Battery Indicator:

Yellow blinking

Signal indictor: No

colour;

Battery Indicator:

Red blinking

9 10

Enter PIN code and

then the “ #” Key.

Enter PUK code, the

“*” Key, New PIN, the

“*” Key again, New

PIN again, and then

the “#” Key.

Contact your service

provider.

Useful Tips



Dial “1” to access your voicemail. To access or set-up your

voice mail, simply press and hold the “1” key, or press *98.



The “Phone 2” port can be used to connect an additional

phone, or cordless base station. All telephones connected

to the wireless home phone base station will use the same

telephone number.

For more information, please refer to the detailed User Guide

onlineatwww.rogers.com/userguide.comorwww.do.ca