ZTE Unite Quick Start Guide
LEGAL INFORMATION
Copyright © 2012 ZTE CORPORATION.
All rights reserved.
No part of this publication may be excerpted, reproduced, translated or utilized in
any form or by any means, electronic or mechanical, including photocopying and
microlm, without the prior written permission of ZTE Corporation.
The guide is published by ZTE Corporation. We reserve the right to make modi-
cations on print errors or update specications without prior notice.
ZTE Unite is a trademark of the ZTE Corporation.
U.S. Cellular® and the U.S. Cellular logo are the trademarks of the United
States Cellular Corporation.
Version No.: 1.0
Edition Time: 10 16, 2012
1
Getting Started
The following gure shows the appearance of your ZTE Unite, it is only for your
reference. The actual device may be different.
SCREEN
UP BUTTON
DOWN BUTTON
OK BUTTON
POWER SWITCH
MICRO USB PORT
RESET BUTTON
2
Screen Indicators
Icon Description Icon Description
Battery Status 4G LTE Network
3G Network CDMA 1X Network
Data Connected Signal Strength
Roaming Signal
Strength
and
No SIM Card In-
serted
No Network Service
Text Message New Text Message
Text Message Full Settings
3
Roaming
PIN enabled SIM card or
Incorrect SIM card inserted
Number of current
Wi-Fi connections
About Your SIM Card
Your ZTE Unite requires a SIM card. Prior to turning on your ZTE Unite please
insert the SIM card included in the package into the device. This SIM card will only
work with your ZTE Unite. Once the SIM card has been inserted, do not remove!
If you r SI M ca rd is ever se pa ra te d fr om you r ZT E Unite or da ma ge d, the
device will not function. If you experience any issues with your ZTE Unite, contact
Customer Service at 1-888-944-9400 or visit your nearest U.S. Cellular® retail
location.
Hardware Installation
Installing the 4G LTE SIM Card
If you have not already done so, please follow these instructions for the installation
of your new SIM card which is in the package:
1. Remove the SIM card from the outer card, being careful not to touch the gold
contacts.
2. Turn the power off. Remove the battery cover and take the battery out. Locate
the SIM card slot. Hold the card so the writing on the back of the card is facing
you and the gold contact points are properly aligned with the SIM card slot.
4
3. Insert the SIM card into the slot until it is fully inserted.
NOTE: Do not bend or scratch your SIM card. Avoid exposing your SIM card to
static electricity, water or dirt.
Inserting and Charging the Battery
1. Use the thumb catch at the bottom of your ZTE Unite to open the battery cover
and align the battery contacts with the terminals in the battery compartment as
shown. Push the battery down until it clicks into place.
5
Loading...