ZTE AC8710 User Manual

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

CDMA2000 1X EV-DO

Wireless Data Terminal

User Guide

This User Guide is used for Wireless Data Terminal of AC8710.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

All rights reserved. No part of this publication may be excerpt ed, reproduced, translated or utiliz ed in any form or by any means, electronic or mechanical, including photocopying and microfilm, without the prior written permission of ZTE Corporation. ZTE Corporation reserves the right to make modifications on print errors or update specifications in this manual without prior notice.

V1.0, Nov. 2007

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

Table of Contents

1. Introduction.............................................................................................................................1

2. Precautions..............................................................................................................................1

3. Appearance .............................................................................................................................2

3.1 Introduction.........................................................................................................................2

3.2 Insert R-UIM Card..............................................................................................................2

3.3 Operation Guide of Data Cable...........................................................................................3

4. Install and Uninstall................................................................................................................4

4.1 Windows 2000 ...................................................................................................................5

4.1.1 Install........................................................................................................................5

4.1.2 Uninstall...................................................................................................................9

4.2 Windows XP ....................................................................................................................10

4.2.1 Install......................................................................................................................10

4.2.2 Uninstall.................................................................................................................15

4.3 Windows Vista .................................................................................................................16

4.3.1 Install......................................................................................................................16

4.3.2 Uninstall.................................................................................................................20

4.4 Manually Install Through Other USB Port .......................................................................21

4.4.1 Windows 2000........................................................................................................21

5. Run the Application..............................................................................................................22

6. Connect/Disconnect..............................................................................................................23

7. Connection Records..............................................................................................................24

8. Voice Call.................................................................................................................................25

9. Call History .............................................................................................................................28

10. Short Message......................... ... .............................. ... .. ............................... .. .. ......................29

11. Phone Book............................................................................................................................31

12. Setting........................... ............................... .. ... .. .............................. ... ... ...............................33

13. Help ........................................ ... .. ... ... .............................. .. ... .............................. ... ................36

14. Connect to the Website ...... ... .............................. .............................. ............................... . .....36

15. Trouble-shooting....................................................................................................................37

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

1. Introduction

Thank you for choosing AC8710 CDMA2000 1X EV-DO Wireless Data Terminal (hereinafter referred to as Data Terminal) of ZTE Corporation.

The

Data Terminal equips with a standard USB interface and supports both CDMA2000 1X

EV-DO and CDMA2000 1X network. In the area where there is signal, it allows you to go surfing on the Internet, send

& receive short messages, and make & receive phone calls.

2. Precautions

¾ Please don’t use the product near flammable or explosive materials because it might cause

failure or fire.

¾ Keep the product away from high temperature, humidity, or dust because it might cause

failure.

¾ Avoid shock, cast or impact. Please keep the product well when you don’t use it. ¾ Do not unplug the antenna. Damage cause by misuse is not covered by this warranty. ¾ Don’t use the product near the place where is weak signal or high-precisi on electronic device

because the magnetic interference might cause the misoperation of electronic device or other problems.

¾ Please make sure to quit the application before pulling out the terminal, otherwise it would

damage the terminal or affect the normal operation of the system.

¾ Please don’t insert or pull out the card with great force to avoid damaging the interface.

¾ This device has been tested for FCC RF exposure body SAR compliance with typical laptop

computers. In order to comply with FCC RF exposure requirements, AC8710 CDM A data terminal user is recommended to have good knowledge on RF exposure. During operation, a 1.5cm separation distance should be maintained between the antenna, whether extended or retracted, and the user’s/bystander’s body (excluding hands, wrists, feet, and ankles) to ensure FCC RF exposure compliance.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

3. Appearance

3.1 Introduction

Tap

Antenna

Top View Rear View

USB Interface

R-UIM Card Cover

Host

LED

LED status descriptions:

Inserting

LED

Yellow ON OFF Slow Flash OFF Quick Flash OFF Flash

Green ON

the data terminal

Network Registered

EV-DO 1X EV-DO 1X EV-DO 1X

Slow Flash

OFF

Service available or Searching for the network

Quick Flash

OFF Flash OFF

Upon an incoming call(as the terminal supports voice call)

3.2 Insert R-UIM Card

Note: If your data terminal does n’t need R-UIM card, please skip this section.

1. Pull out the tap；

2. Take out the R-UIM card cover in the direction indicat e d by the arro w；

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

3. Insert R-UIM card as below figure；

4. Push back R-UIM card cover in the direction indicated by the arrow.

3.3 Operation Guide of Data Cable

Generally, the Data Terminal could be directly connected with USB port. You could also connect the Data Terminal with PC by using the accompanying data cable, as shown in the following figure. Connect Interface ① with Data Terminal, and interface ② with PC's US B port. If the power supply from USB port is insufficient, connect both interface ② and ③ with USB port together.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

4. Install and Uninstall

System Requirements:

The Data Terminal supports the following operating system:

¾ Windows 2000 ¾ Windows XP ¾ Windows Vista

PC minimum configurations:

CPU Pentium-II/233MHz USB interface

2.0 (USB1.0 and 1.1 compatible) Optical Drive CD-ROM (for installation only) Memory 64 MB Disk Space 50 MB (used for installation of application)

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

4.1 Windows 2000

4.1.1 Install Note: Do not insert the Data Terminal before installation.

1、Find “Setup.exe” firstly in Data Terminal CD-ROM, double-click it to display the Welcome picture, and then click “Next”;

2、Select the location where you want the program to be installed, and then click “Next”;

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

3、Select Start Menu folder, and then click “Next”;

4、When you see the window below, please click “Install”;

5、Please wait for installation.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

6、Please insert the Data Terminal into USB interface if the system prompts you to insert the hardware (If it has been inserted, please unplug it and insert again.)

7、The system shall find the new hardware and install the driver automatically. Just wait a minute;

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

8、The driver is installed successfully. Pleas click “OK”;

9、Click “Finish” to close the last screen of the wizard. Now you can start the application for Data Terminal.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

4.1.2 Uninstall

1、Select Start -> Programs -> ZTE Wireless Terminal -> Uninstall ZTE Wireless Terminal. Click “Uninstall ZTE Wireless Terminal”, and you will be asked if you want to remove the program. Click “Yes”;

2、Please wait;

3、Click “OK” when un-installation is completed;

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

4.2 Windows XP

4.2.1 Install Note: Do not insert the Data Terminal before installation.

1. Find “setup.exe” firstly in the Data Terminal CD-ROM, double-click it to display the

Welcome picture, and then click “Next”;

2. Select the location where you want the program to be installed, and then click “Next”;

ZTE Corporation http://www.zte.com.cn

+ 29 hidden pages