Zebra Technologies MD 1356NFC Installation Guide

Installation Guide

1356NFC-ZQ500

Compliance and Statements

FCC Compliance Statement (USA)

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for Class B Digital Devices,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a residential environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the product manuals, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, the
user is encouraged to do one or more of the following measures:

•

•

•

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
Consult the dealer or an experienced RF service technician for help.

•

The end product must be labeled, in a visible area, with the following:

Contains FCC ID: I28MD-1356NFC

Modification Warning

The user is cautioned that any changes or modifications not expressly approved by Zebra
Technologies could void the user s authority to operate the equipment. To ensure compliance, this
printer must be used with fully shielded communication cables.

RF Exposure Statement

This transmitter complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter, except in accordance with FCC multi- transmitter product procedures.