Contents oF the Box GettinG started
Mount the Battery Charger (if bracket was purchased).
1
Attach the Mounting Bracket
to the wall using the 4 screws
with washers included in the
MT2031 Mounting Bracket Kit.
See the location guide overleaf
for dimensions.
Note: Wall mount or Desk mount bracket
configuration is not recommended when
charging Ikôn CH3000 battery packs.
Insert the two mounting screws from the Kit into the holes
through the top of the Battery Charger and tighten to the
Mounting Bracket to secure it.
> ST3006
6-Slot Battery Charger
for Omnii and Ikôn
> This Guide
> Regulatory and
Warranty Guide
(not shown)
> AC Power Supply
(requires an IEC320-C13
power cord approved by
Psion, sold separately)
Optional - must be ordered separately
Country-specific
Power Cord
MT2031 Mounting
Bracket Kit
(contains Wall Mount
Bracket, 4 wall
screws, 4 washers,
2 screws for Charger)
Features
toP
Charging compartments (6)
Charger mounting
holes (2)
Wall mounting
holes (4)
Screwdriver access
holes (4)
Mounting holes (2)
Connect the Battery Charger to External Power.
Warning: Use an IEC320-C13 power cord approved by
Note: The LEDs light when first connected to power.
Choke
Psion, with the ground pin connected to a proper
earth-grounded receptacle. Check with a qualified
electrician if you are uncertain of your receptacle
grounding.
IEC320-C13
Wall bracket
AC/DC adaptor
Bottom of
charger
Insert One or More Batteries for Charging.
32
Insert the battery by placing the base into the slot in line with
the pins and pivoting the top of the battery into the charge
compartment.
Then snap the battery tabs into place.
Allow the Batteries to Charge for 3-4 Hours.
4
Charge indicator LEDs (set of 4 per compartment)
BottoM
Bracket mounting holes (2)Drain holes (6)
Rubber feet (5)
DC In connector
Final position with AC/
DC Adaptor in place.
(attachment to either
surface is optional)
Wall mount
Desk mount
DC input plug
Power cord
(sold separately)
AC outlet
Note: Use only the universal AC/DC power adaptor approved by Psion
for use with the Battery Charger.
Note: Full battery performance is only reached after the first few
charge/discharge cycles. A table of the charge status indicated by the LEDs is shown overleaf.
0 - 40 °C
32 - 104 °F
3-4 h
over
>
CharGe status indiCator Leds
LoCation Guide For MountinG sCrews
st3006
Set of four LEDs per
charging compartment.
Charge status is indicated by the following LEDs.
Battery error or charging timeout
(solid RED)
Battery out of charging temperature range
(flashing YELLOW)
Battery capacity (25% capacity per bar) (flashing GREEN)
Fully Charged
25%
50%
75%
(all LEDs solid GREEN)
100%
The mounting screws on
the bracket are M4 x 6mm
panhead screws.
6-sLot Battery
CharGer
QuiCk start
Guide
© Copyright 2011 by Psion Inc.
Psion, Psion Teklogix, Omnii, and Ikôn are trademarks of Psion Inc. Other product names
mentioned in this document are trademarks or registered trademarks of other hardware,
software, or service providers and are used herein for identification purposes only.
March 16, 2011
PN 8000204.B
ISO 9001 Certified
Quality Management System
Loading...