MOUNTING
BRACKET
INSTALLATION
GUIDE
CRADLE SETUP
1. Remove the backing from the black
rubber pad and place onto the back
of the Ten Slot Charging Cradle as
shown.
2. Place the power supply into the
2
Power Supply
Zebra reserves the right to make changes to
any product to improve reliability, function, or
design. Zebra does not assume any product
liability arising out of, or in connection with, the
application or use of any product, circuit, or
application described herein. No license is
granted, either expressly or by implication,
estoppel, or otherwise under any patent right or
patent, covering or relating to any combination,
system, appar
or process in which Zebra products might be
used. An implied license exists only for
equipment, circuits, and subsystems contained
in Zebra products.
atus, machine, material, method,
mounting tabs.
3. Plug the AC line cord into the power
supply.
4. Wrap the power supply cord around
the cable guides.
5. Plug the power plug into the power
port on the cradle.
6. Snap the ferrite into the mounting
slot.
7. Place the four mounting bracket
tabs into the slots on the cradle.
8. Slide the mounting bracket up until
the tabs enter the slots.
9. Secure the mounting bracket to the
cradle using the two supplied
screws. Torque to 20 kgf-cm
(1.45 lbf-ft).
Cable Guides
1
4
3
Black Rubber Pad
Mounting Tabs
5
7
Tab
8
Mounting Slot
9
Input Power Plug
Zebra Technologies Corporation
Lincolnshire, IL U.S.A.
http://www.zebra.com
Zebra and the Zebra head graphic are
registered trademarks of ZIH Corp. The
Symbol logo is a registered trademark of
Symbol Technologies, Inc., a Zebra
Technologies company.
© 2015 Symbol Technologies, Inc.
72-167295-02 Revision A — February 2015
Ferrite
6
WALL MOUNT
CAUTION:
Use mounting hardware (screws
and/or anchors) appropriate for
RACK MOUNT
58.7 mm
2.31 in.
the type of wall mounting the
bracket onto. The Mount Bracket
mounting slots dimensions are
5 mm (0.2 in.). Fasteners must be
able to hold a minimum of 4.5 Kg
(10 lbs.)
For proper installation consult a
professional installer. Failure to
install the Wall Mount Bracket
properly can possibly result in
damage to the hardware.
1. Mark the four screw hole
locations and drill holes.
2. Install the four screws
and/or anchors into the
wall.
215 mm
8.46 in.
2.5 mm
0.01”
2.5 mm
0.01”
3. The screw heads should
protrude 2.5 mm (0.01”)
from the wall.
4. Align the mounting
bracket’s mounting holes
with the screws. Place the
bracket/cradle assembly
on the screws.
5. Slide the bracket/cradle
assembly to the left and
down.
Loading...