RS5100 Back of Hand Mount
Installation Guide
Back of Hand Mount
The Back of Hand Mount (which includes a hand strap), allows the
RS5100 to be worn on the back of your hand and provides a remote finger
trigger. It is one size to fit all and is ambidextrous.
To attach the back of hand mount, perform the following three steps:
1. Install the strap to the back of hand assembly (there is a difference for
a right hand user and a left hand user)
2. Position the back of hand mount on the hand
3. Install the RS5100 onto the back of hand mount.
Install Strap: Right Hand User
To install the strap to the back of hand assembly for a right hand user:
1.
Hold the Y shape strap in one hand and the back of hand assembly in
the other hand.
2. Slide one end of the strap with the snap through the top left slot on the
back of hand assembly and snap into place.
3. Slide the other end of the strap with the snap through the bottom left
slot on the back of hand assembly and snap into place.
4. Slide the remaining long end of the strap with the velcro through the
right center slot of the back of hand assembly and velcro in place.
3. Slide the other end of the strap with the snap through the bottom right
slot on the back of hand assembly and snap into place.
4. Slide the remaining long end of the strap with the velcro through the
left center slot of the back of hand assembly and velcro in place.
Position Strap on Hand
To position the back of hand mount on the hand:
1. Slide your hand through the strap, with your thumb through the
smaller opening between the two snaps and your remaining four
fingers through the larger opening.
Install Strap: Left Hand User
To install the strap to the back of hand assembly for a left hand user:
1. Hold the Y shape strap in one hand and the back of hand assembly in
the other hand.
2. Slide one end of the strap with the snap through the top right slot on
the back of hand assembly and snap into place.
2. Adjust the velcro to a comfortable position.
3. Pull the finger trigger to place it over your index finger and slide the
finger trigger down the index finger.
4. Rotate the finger trigger so that the trigger button is easy access to
your thumb.
Install RS5100
To install the RS5100 onto the back of hand mount:
1. Align the contacts on the RS5100 assembly with the contacts on the
back of hand mount and engage the slot (located at the top of the
RS5100 on the backside) on the RS5100 with the opening at the top
of the back of hand mount.
Detach RS5100
To detach the RS5100 from the back of hand mount, press the release
buttons on both sides of the back of hand mount using your thumb and
middle finger, and lift the RS5100 off the back of hand mount using your
index finger.
2. Push down on the RS5100 to snap into place.
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corporation, registered in
many jurisdictions worldwide. All other trademarks are the property of their respective owners. ©2020
Zebra Technologies Corporation and/or its affiliates. All rights reserved.
MN-003973-01EN Rev A 05/20
Loading...