DS8108 DOCUMENT CAPTURE STAND
Document Capture Base
Neck in
Stand Base
Cup
Logo Label
Document
Document Capture Base
Document Guides
Neck
Arm
Cup
Arm
Cup Lock
Screw
Neck Lock Screw
Document
Guides
Neck Lock
Screw
Neck Lock
Screw Pin
Cup Dock
Cup
Lock
Screw
Base
Neck
Screw
Pin
Slot
Screw
Pin
Ta b
Cup Position
Line
Cup Dock
Position Line
ASSEMBLY INSTRUCTIONS
The DS8108 Document Capture Stand provides hands-free
digital imaging operation. The stand components, shown below,
ship in two boxes: Document Capture Base (p/n STNDDC0081C-04); and, Cup and Neck in Stand Base (p/n 2066483-02R).
The stand can be used with the digital scanner to capture
images on paper sizes up to A4 and letter (8½ in x 11 in).
Assembly
MN-002998-01 Revision A March 2017
1. Turn the neck lock screw counterclockwise and remove the
neck lock screw and neck lock screw pin.
2. Lift the neck out of the base and turn it 180 degrees so that
the cup lock screw faces front (as shown).
3. Insert the neck into the base to the highest allowable height
for the maximum field of view. The neck can be lowered as
needed to decrease the field of view and increase
resolution for smaller sized documents.
4. Replace the neck lock screw pin and neck lock screw.
Ensure the screw pin tab fits into the screw pin slot.
5. Turn the neck lock screw clockwise until tight.
6. Remove the cup lock screw from the cup dock, if
applicable.
7. Attach the cup to the cup dock, interlocking the grooves.
IMPORTANT: For proper document capture, the position lines on the
cup and the cup dock should appear as shown in the diagram above.
The position line on the cup dock should be one groove above the
position line on the cup.
Zebra and the stylized Zebra head are trademarks of ZIH Corp., registered in
many jurisdictions worldwide. All other trademarks are the property of their
respective owners. © 2017 Symbol Technologies LLC, a subsidiary of Zebra
Technologies Corporation.
8. Replace the cup lock screw and turn clockwise until tight.
A4
Letter
A4
Letter
Center of Page
Indicator
11. Place the digital scanner in the cup.
9. Slide the assembled stand into the document capture base.
10. Slide out the Document Capture Base arms.
12. Position the paper so that it touches the Document Capture
Base. The paper should align left and right with the
matching guides on the arms of the base to ensure the
document is in the correct field of view.
NOTE: Ensure to line up the edges of the paper with the marks
on the document guides, if appropriate.
13. Follow the instructions in the DS8108 Digital Scanner
Product Reference Guide (p/n MN-002926-xx) to initiate an
image capture or document capture session.
Loading...