Zanussi ZWG1100 P, ZWG1121 P User Manual
User manual
EN
Washing Machine
ZWG1121 P
ZWG1100 P
147214441
2
Contents
Safety information
In the interest of your safety and to
ensure the correct use, before installing
and first using the appliance, read this
user manual carefully, including its hints
and warnings.
Important!
To avoid unnecessary mistakes and
accidents, it is important to ensure that
all people using the appliance are
thoroughly familiar with its operation and
safety features.
Save these instructions and make sure
that they remain with the appliance if it is
moved or sold, so that everyone using it
through its life will be properly informed
on appliance use and safety.
General safety
It is dangerous to alter the specifications or
attempt to modify this product in anyway.
Wash small items such as socks, laces,
washable belts etc in a washing bag or
pillow case as it is possible for such items
to slip down between the tub and the inner
drum.
Do not use your washing machine to wash
articles with whalebones, material without
hems or torn material.
Always unplug the appliance and turn off
the water supply after use and before
cleaning or maintenance.
Under no circumstances should you attempt
to repair the machine yourself. Repairs
carried out by inexperienced persons may
cause injury or serious malfunctioning.
Contact your local Service Centre. Always
insist on genuine spare parts.
During high temperature wash program the
door glass may get hot. Do not touch it!
Make sure that small pets do not climb into
the drum. To avoid this, please check into
the drum before using the appliance.
Any objects such as coins, safety pins,
nails, screws, stones or any other hard,
sharp material can cause extensive damage
and must not be placed into the machine.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Only use the advised quantities of fabric
softener and detergent. Damage to the
fabric can ensue if you overfill. Refer to the
manufacturer’s recommendations of
quantities.
Safety information .....................................
Environment concerns...............................
Product description...................................
Technical data...........................................
Installation.................................................
First use....................................................
Daily use...................................................
2
4
5
5
6
8
8
Control panel.............................................
Set your washing program.........................
International wash code symbols................
Programs informations...............................
Washing programs....................................
Care and cleaning.....................................
Something not working..............................
11
12
15
16
17
18
20
3
Installation
This appliance is heavy. Care should be
taken when moving it.
When unpacking the appliance, check that
it is not damaged. If in doubt, do not use it
and contact the Service Centre.
All packing and transit bolts must be
removed before use. Serious damage can
occur to the product and to property if this
is not adhered to. See relevant section in
the user manual.
After having installed the appliance, check
that it is not standing on the inlet and drain
hose and the worktop is not pressing the
electrical supply cable.
If the machine is situated on a carpeted
floor, please adjust the feet in order to allow
air to circulate freely.
Always be sure, that there is no water
leakage from hoses and their connections
after the installation.
Any plumbing work required to install this
appliance should be carried out by a
qualified plumber.
Any electrical work required to install this
appliance should be carried out by a
qualified electrician.
This appliance is designed for domestic
use. It must not be used for purposes other
than those for which it was designed.
Only wash fabrics which are designed to be
machine washed. Follow the instructions on
each garment label.
Do not overload the appliance. See the
relevant section in the user manual.
Before washing, ensure that all pockets are
empty and buttons and zips are fastened.
Avoid washing frayed or torn articles and
treat stains such as paint, ink, rust, and
grass before washing. Underwired bras
must NOT be machine washed.
Garments which have been in contact with
volatile petroleum products should not be
machine washed. If volatile cleaning fluids
are used, care should be taken to ensure
that the fluid is removed from the garment
before placing in the machine.
Use
Never use the washing machine if the power
supply cable, the control panel, the working
surface or the base are damaged so that the
inside of the washing machine is accessible.
Never pull the power supply cable to remove
the plug from the socket; always take hold of
the plug itself.
This washing machine is not intended for
use by young children or infirm persons
without supervision.
Young children should be supervised to
ensure that they do not play with the
appliance.
The packaging components (e.g. plastic film,
polystyrene) can be dangerous to children danger of suffocation! Keep them out of
children’s reach
Make sure that children or pets do not climb
into the drum. To avoid this the machine
incorporates special feature.
To disable this device and restore the
possibility of closing the door, rotate the
button anti-clockwise until the groove is
vertical.
To activate this
device, rotate the
button (without
pressing it) inside
the door clockwise
until the groove is
horizontal. If
necessary use a
coin.
Keep all detergents in a safe place out of
children’s reach.
Child safety
Packaging materials
The materials marked with the symbol are
recyclable.
>PE<=polyethylene
>PS<=polystyrene
>PP<=polypropylene
Old machine
Ecological hints
This means that they can be recycled by
disposing of them properly in appropriate
collection containers.
Use authorised disposal sites for your old
appliance. Help to keep your country tidy!
To save water, energy and to help protect the
environment, we recommend that you follow
these tips:
Normally soiled laundry may be washed
without prewashing in order to save
detergent, water and time (the environment
is protected too!).
The machine works more economically if it is
fully loaded.
The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it shall
be handed over to the applicable collection
point for the recycling of electrical and
electronic equipment.
By ensuring this product is disposed of
correctly, you will help prevent potential
negative consequences for the environment
and human health, which could otherwise be
caused by inappropriate waste handling of this
product.
For more detailed information about recycling
of this product, please contact your local city
office, your household waste disposal service
or the shop where you purchased the product.
4
Environment concerns
With adequate pre-treatment, stains and
limited soiling can be removed; the laundry
can then be washed at a lower temperature.
Measure out detergent according to the
water hardness, the degree of soiling and the
quantity of laundry being washed.
4
3
2
1
Water Drain Hose
9
Door Opening Handle
4
Control Panel
3
Worktop
2
Detergent Dispenser Drawer
1
6
10
Hose Holders
11
Back Feet
Water Inlet Hose
6
Front Feet
5
Mains Cable
8
Drain Hose Support
7
10
9
8
7
5
11
5
Product description
Technical data
85 cm
60 cm
54 cm
Height
Width
Depth
0,8 MPa
0,05 MPa
Maximum
Minimum
Cottons
Synthetics
Delicates
Hand Wash
Maximum Load
Water supply pressure
Maximum :
Model :
Spin Speed
Dimensions
220-240 V/50 Hz
2000 W
10A
6.0 kg
2.0 kg
2.0 kg
1.0 kg
1200 rpm1000 rpm
ZWG1121PZWG1100P
Power supply voltage/frequency
Total power absorbed
Minimum fuse protection
Front View Back View
6
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
Using a spanner
unscrew and
remove the two
rear bottom
screws.
Slide out the two
plastic pins.
Lay the machine on its back ensuring that
the hoses are not crushed.
Place one of the
polystyrene angle
packings under
the machine.
Cover all the open holes with the plugs
which you can find in the bag containing
the instruction booklet.
Remove the
polystyrene block
(A) protecting the
motor.
Important!
A
Remove the polystyrene base, set the
machine upright and unscrew the remaining
rear screw. Slide
out the relevant
pin.
7
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or cupboard units.
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch.
This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.
In this case, make
sure the end cannot
come unhooked when
the machine is
emptying.
Connect the water inlet hose to a tap with
3/4” BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned in
any direction.
Simply loosen the fitti
ng, rotate the hose and
retighten the fitting, making sure there are no
water leaks.
Water inlet
Never place cardboard, wood or similar
materials under the machine to compensate
for any unevenness in the floor.
Carefully level by
screwing the
adjustable feet
in or out.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
Water drainage
For the correct functioning of the machine
the drain hose must remain hooked on the
proper support piece situated on the top
part of back side of the appliance.
90 cm
60 cm
8
Electrical Connection
This machine is designed to operate on a
220-240 V, single-phase, 50 Hz supply.
“An incorrect power supply may void your
warranty.”
Check that your domestic electrical installation
can take the maximum load required (2.0 kW),
also taking into account any other appliances
in use.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution. Should the
appliance power supply cable need to be
replaced, this should be carried out by our
Service Centre.
Connect the machine to an earthed socket.
Important!
Ensure that the electrical and water
connections comply with the installation
instructions.
Run a cotton cycle at 90 °C, without any
laundry in the machine, to remove any
manufacturing residue from the drum and
tub. Pour 1/2 a measure of detergent into
the dispenser drawer and start the machine.
First Use
Daily Use
Follow the wash code symbols on each
garment label and the manufacturer’s washing
instructions. Sort the laundry as follows: whites,
coloureds, synthetics, delicates, woollens.
Sorting the laundry
Button up pillowcases, close zip fasteners,
hooks and poppers. Tie any belts or long
tapes.
Rub particularly soiled areas with a special
detergent or detergent paste. Treat curtains
with special care. Remove hooks or tie them
up in a bag or net.
Never wash whites and coloureds together.
Whites may lose their “whiteness” in the
wash.
New coloured items may run in the first
wash; they should therefore be washed
separately the first time.
Remove persistent stains before washing.
Make sure that no metal objects are left
in the laundry (e.g. coins, hair clips,
safety pins, pins).
Before loading the laundry
Blood: treat fresh stains with cold water. For
dried stains, soak overnight in water with a
special detergent then rub in the soap and
water.
Oil based paint: moisten with benzine stain
remover, lay the garment on a soft cloth and
dab the stain; treat several times.
Dried grease stains: moisten with turpentine,
lay the garment on a soft surface and dab the
stain with the fingertips and a cotton cloth.
Stubborn stains may not be removed by just
water and detergent. It is therefore advisable to
treat them prior to washing.
Removing stains
Loading...