Zanussi ZHC955X User Manual

Contents
Safety warnings..................................................................................................................................................... 3
For the installer ........................................................................................................................................................3
For the user .............................................................................................................................................................. 3
Description of the appliance .............................................................................................................................. 4
Extraction mode ....................................................................................................................................................... 4
Recirculation mode ..................................................................................................................................................4
Correct ventilation ....................................................................................................................................................5
Cleaning the hood .................................................................................................................................................... 6
Metal grease filter .................................................................................................................................................... 6
Removing the metal grease filter ............................................................................................................................. 6
Charcoal filter ..........................................................................................................................................................7
Changing the light bulb .............................................................................................................................................7
What to do if ......................................................................................................................................................... 8
UK
Special accessories*............................................................................................................................................ 8
Technical Specifications ...................................................................................................................................... 8
Technical assistance service.............................................................................................................................. 9
Guarantee Conditions ....................................................................................................................................... 10
Installation .......................................................................................................................................................... 11
Unpacking .............................................................................................................................................................. 11
Placement .............................................................................................................................................................. 11
Electrical connection .............................................................................................................................................. 11
Wall unit mounting ..................................................................................................................................................12
Before installing or using this appliance please read this instruction book carefully paying particular attention to the safety warnings on the following page. If you have any queries regarding this appliance please contact Customer Care for advice. Please keep this instruction book for future reference and pass it on to any future owner of the appliance.
2
Safety warnings
For the installer
When used as an extractor unit, the hood must be fitted with a 150mm diameter hose.
Attention: The hose is not supplied and must be purchased separately.
When installing the hood observe the following minimum distances from the cooking top: electric cookers 500 mm
gas cookers 700 mm
The hood can be installed above these heights but for optimum performance it should be installed at the distance quoted for the appropriate heat source.
The national Standard on fuel-burning systems specifies a maximum depression of 0.04 mbar in such rooms.
The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.
The air outlet installation must comply with the regulations laid down by the relevant local authorities.
When the unit is used in extraction mode, a sufficiently large ventilation hole must be provided, with dimensions that are approxi­mately the same as the outlet hole.
National and regional building regulations impose a number of restrictions on using hoods and fuel-burning appliances connected to a chimney, such as coal or oil room-heaters and gas fires, in the same room.
Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approxi­mately 500-600 cm possibility of a depression being created during operation of the hood.
If you have any doubts, contact the relevant controlling authority or building inspector’s office.
Since the rule for rooms with fuel burning appliances is “outlet hole of the same size as the ventilation hole”, a hole of 500-600 cm is to say a larger hole, could reduce the perfor­mance of the extractor hood.
If the hood is used in its recirculation mode, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures.
When the hood is used in its extraction mode, the following rules must be followed to obtain
2
large to avoid the
2
, which
optimal operation: — short and straight outlet hose — keep bends in outlet hose to a minimum — never install the hoses with an acute angle, they must always follow a gentle curve. — keep the hose as large as possible (preferably the same diameter as the outlet hole). — the length should be no more than:
3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the
efficiency of the hood and reduce the airflow.
Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood.
3
For the user
The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.
Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control.
The hot oil in the frying pan might ignite due to overheating.
The risk of self-ignition increases when the oil being used is dirty.
It is extremely important to note that overheating can cause a fire.
Never carry out any flambé cooking under
the hood.
Always disconnect the unit from the power supply before carrying out any work on the hood, including replacing the light bulb
(take the cartridge fuse out of the fuse holder or switch off the automatic circuit breaker).
It is very important to clean the hood and
replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, resulting in a fire hazard.
The appliance is not intended for use by young children or infirm persons without supervision.
Older children must be supervised if using the appliance.
Young children should be supervised to ensure that they do not play with the appliance.
WARNING - Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
on the product, or on the documents accompanying the product, indicates that this appliance
4
Description of the appliance
The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
The hood is supplied as a recirculator unit and can also be used in extraction mode by not installing/using the charcoal filters.
Attention! The charcoal filters are attached to one side of the polystyrene protection panels in the packaging and should be fitted into place prior to using the cooker hood in the recirculation mode.
Extraction mode
In this mode fumes are extracted to the outside via a hose connected to the coupling ring A. Fig. 1.
In order to obtain the best performance the hose should have a diameter equal to the outlet hole.
Fig. 1
A
Recirculation mode
The air is filtered through a charcoal filter and returned to the kitchen.
You will need an original charcoal filter for the recirculation mode. (See Special Accessories).
Control Panel
Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit bottom.
Light switch
Motor switch
Correct ventilation
If the cooker hood is to work correctly there must be an under pressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open.
Fig. 2
5
Maintenance and care
The hood must always be disconnected from the electricity supply before beginning any maintenance work.
Cleaning the hood
Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid.
Never use corrosive, abrasive or flammable cleaning products or products containing bleach.
Never insert pointed objects in the motor’s protective grid.
Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid.
It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard.
Metal grease filter
The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks.
Warning
Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.
Removing the metal grease filters
Push it towards the back of the unit and then pull it down and out.Fig. 3.
Hand washing
Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry.
Dishwasher
Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance.
Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes).
Fig. 3
6
Loading...
+ 11 hidden pages