Zanussi ZEBF336 User Manual

REFRIGERATOR-
FREEZER
ZEBF 336
INSTRUCTION BOOKLET
2222 313-33
3
CONTENTS
Instructions for the User
Important Safety Information
2
Operation
4
Before using 4
Control panel 4
Start your appliance 4
Temperature control 4
Freezing fresh food 5
Frozen food storage 5
Thawing 6
Making ice cubes 6
Cold accumulators 6
Fresh food refrigeration 6
Freezing calendar 6
Movable shelves 7
Positioning the door shelves 7
Humidity control 7
Drawer 7
Hints and Tips
8
Maintenance and Cleaning
9
Internal cleaning 9
External cleaning 9
When the appliance is not in use 9
Changing the light bulb 9
Defrosting 10
Something Not Working
11
Service and Spare Parts
12
Customer Care
12
Guarantee Conditions
13
Instructions for the Installer
Technical Specification
14
Installation
15
Positioning 15
Rear Spacers 15
Electrical Connection
16
Door Reversal
17
17
G
H
F
D
PR18
F
F
F
E
E
Printed on recycled paper
Door reversal directions
1. Disconnect from the electricity supply.
2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing;
3. Remove the ventilation grill (D).
4. remove the bottom hinge (E) by unscrewing its fixing screws;
5. Remove the freezer door by releasing it from the middle hinge (H).
6. Unscrew the middle hinge.
7. Remove the fridge door by releasing it from the top hinge pin (G).
8. Remove the pin then mount these on the side, after having removed the small plugs which should then be fitted on the opposite side.
9. reassemble the door;
10. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge;
11.Refit the fridge door and replace the middle hinge to the left hand side.
12.reassemble the lower hinge (E) on the opposite side, using the screws previously removed. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side;
13.refit the ventilation grille (D), clipping it into place;
The doors can be aligned by adjusting the middle hinge.
The middle hinge can be adjusted horizontally, after having slackened the two screws with a screwdriver.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
D419
ABCD E
F G
5
- frequent door openings,
it may be necessary to select a more suitable setting.
To obtain a colder temperature, turn the thermostat control to the larger ; to obtain a warmer temperature turn the control to the smaller
●.
Freezing fresh food
In any 24 hour period you can freeze up to 13 kg of fresh food.
When you first start the freezer or after a period of non-use, press the fast freeze switch 12 hours before you want to freeze your food (the yellow light (B) illuminates).
If the freezer is already in operation, the fast-freeze knob should be activated about 2-3 hours before freezing fresh food.
This time can be shortened, depending on the quantity of food to be frozen. After the time has elapsed place the food to be frozen in the upper compartment of the freezer as these are the coldest parts.
In order to freeze the quantity indicated on the rating plate, arrange the food directly in contact with the cooling surfaces. If the food is frozen in the baskets, the maximum quantity that can be frozen is slightly less. Once the food is completely frozen (which could take up to 24 hours) press again the fast freeze switch; the yellow light (B) goes off.
Distribute the frozen food packages in the other compartments, so that the top compartments can be used for a further freezing operation.
- The food to be frozen must be fresh and of the best quality.
- Do not allow fresh food to touch food which is already frozen.
- During the freezing process, ensure that the freezer door remains closed.
Frozen food storage
When you first start the freezer or if the freezer has been out of use for some time, we advise you to run your appliance for at least 12 hours in the «fast freeze» mode before storing frozen food.
To obtain the best performance from this appliance, you should: If large quantities of food are to be stored, remove all drawers and baskets from appliance and place food on the cooling shelves. Pay careful attention not to exceed load limit stated on the side of the upper section (where applicable).
Do not exceed the storage period indicated by the manufacturer.
Finally, do not open the door frequently or leave it open longer than is absolutely necessary.
Important
Do not put carbonated liquids, (fizzy drinks etc.), in the freezer compartment.
Ice Iollies, if consumed immediately after removal from the freezer, can possibly result in a low temperature skin burn.
Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or “frost/freezer burns”.
Important
In the event of a power cut do not open the door.The food in the freezer will not be affected if the power cut is short and if the freezer is full. Should the food begin to thaw, it must be consumed quickly and must not be re-frozen.
15
INSTALLATION
Positioning
This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T +18°C to + 43°C
It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.
You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.
Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a tool (see figure).
D200
NP00
100 mm10 mm
10 mm
A
B
Important
IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal”.
Important
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
D594
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
7
Movable shelves
The walls of the refrigerator have runners so that shelves can be positioned as desired.
Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be adjusted in height.
To do this proceed as shown in the diagram.
D338
PR261
Drawer
The drawer is suitable for storing fruit and vegetables. There is a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs.
Humidity control
The glass shelf incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s).
Close the slots to obtain a warmer temperature and greater humidity.
Open the slots to obtain a cooler temperature and less humidity.
PR271
Loading...
+ 14 hidden pages