YSI 4110-3, 4110(W) Operating Manual

BEDIENUNGSANLEITUNG

OPERATING MANUAL

ba76137d04 10/2017

4110(W) / 4110-3

pH ELECTRODES WITH GEL ELECTROLYTE

4110

Contact YSI

1725 Brannum Lane
Yellow Springs, OH 45387 USA
Tel: [phone]

800-765-4974
Email: [e-mail]
Internet: www.ysi.com

Copyright © 2017 Xylem Inc.

2 ba76137d04 10/2017

4110(W) General information

1 General information

Automatic sensor

recognition

The sensor electronics with the stored sensor data are in the connecting
head of the electrode. The data include, among other things, the senso r type
and series number. In addition, the calibration data are stored in the sensor
with each calibration and the calibration history is recorded (the last 10 cali­brations). The data is recalled by the meter when the sensor is connected
and is used for measurement and for measured value documentation.

Storing the calibration data in the sensor ensures that the correct slope and
asymmetry are automatically used if the sensor is operated with different
meters. On the other hand, different calibrated sensors can be used with one
meter without the need to recalibrate.

The digital transmission technique guarantees the failure-free communica­tion with the meter even with long connection cables. The sensor firmware
can be updated via the meter.

ba76137d04 10/2017

3

General information 4110(W)

2 C ommissioning, measuring, calibration

2.1 Commissioning

Scope of delivery  Electrode 4110(W)

 Operating manual

Commissioning Prepare the electrode for measuring as follows:

 Remove the watering cap from the electrode tip. Possible salt deposits in

the area of the watering cap do not affect the measuring characteristics
and can easily be removed with deionized water.

Please keep the watering cap. It is required for the electrode to
be stored. Always keep the watering cap clean.

 Remove any gas bubbles behind the pH membrane by shaking.
 Connect the electrode to the meter.

4110 – via the sensor cable to a free IDS connec-

tor on the meter

4110W – via a connecting cable (accessory) to a

free IDS connector on the meter

or
– wireless via an IDS WA-S adapter (acces-

sory) to a WA-capable meter

Accessories for the connection of the 4110W
sensor to the meter: See chapter 7 W

PARTS AND ACCESSORIES.

EAR

Opening and closing the IDS plug connection,
see section 2.2 O

PLUG CONNECTION.

IDS

PENING AND CLOSING THE

 Calibrate the electrode according to the operating manual of the meter

and observe the following rules while doing so.

4

ba76137d04 10/2017

4110(W) General information

2

4

3

1

Plug connection
closed and locked

Guidance

Groove

2.2 Opening and closing the IDS plug connection

This section only applies to IDS plug variants (4110W).

Opening the plug

connection

Closing the plug

connection

 If necessary, clean the plug connection.
 Open the locking device (step 1).
 Use your thumb and index finger to press the clips of the connector

together, and pull the connector out of the plug (step 2).

 Make sure that the plug connection is completely dry and clean.
 Align the guidance of the connector with the groove in the plug and insert

the connector in the unlocked plug until it catches (step 3).

 Close the locking device (step 4).

ba76137d04 10/2017

5