Yokogawa TX10 Specifications

Thermometers

Bulletin TMTX-E

Simplicity Allows for Ease of Use

TX10 Series of Digital Thermometers

TX10 Series offers thermocouple thermometers that support K, J, E and T type thermocouples.
There are three models available: 1-channel single-function, 1-channel multi-function, and 2-channel
multi-function models.

1-channel Single-function Model (TX1001)

Select the thermocouple type (K, J, E, and T) for

TC TYPE

Operation

DATA HOLD

Multi-function Models (TX1002/03)

● Memory-in Function

Up to ten data items can be stored. When recalled, the stored data
value is displayed with its memory number.

● User calibration function

Calibration and adjustment can be mode easily by operating the panel
keys on instrument and a measurement-standard.

the initial setting.
(The type K is factory-set at shipment)

Press and hold down the TC TYPE key while press­ing the POWER key.
The TX10 enters the thermocouple type selection
mode, and each press of the TC TYPE key switches
between the thermocouple types.
Then accept the setting with the POWER key.

(Make sure that the characters in the display have changed.)

Press this key to hold the measured value.

TC TYPE

CH

(TX1003 only)

DATA HOLD

RECORD

RANGE

READ

REL/

ADJ

Thermocouple type (K, J, E, and T) select key

(Operation is the same as TX1001)

Input channel select key

With each press, the channel switches through the
sequence of “chA,” “chB,” and then “chA-chB.”

Data hold key

A held measured value, can be stored in the
memory of an optional memory number, which is
selected with the ▲, ▼ keys.

· Maximum and minimum record key

Stores the maximum and minimum values from the
time the RECORD key is pressed.

· Data record key

Stores the held measured value in memory. (Up to
ten)

Resolution select key

With each press, resolution alternates between

0.1C and 1C.
(Within the range of -200.0C to 199.9C)

Maximum and minimum values, and stored
data read key

Every time this key is pressed, the maximum and
minimum values, stored data, and the current mea­sured data are displayed in sequence.

· Relative display select key

Displays measured values with reference to the
value obtained immediately before this key was
pressed (relative value). Each press of this key can
select or release the relative display.

· Simplified correction mode key

Sets the correction value, and selects active/inac­tive of the simplified correction function.

Light

Weight:

180 g

(Shown above is the TX1003. The TX1002 has no CH key.)

▲, ▼ Data call-up key

Used to select a memory number when calling up
stored data. Also used to adjust the correction value
for simplified correction mode.