Yealink DECT IP Quick Start Guide
DECT IP Multi-Cell Deployment ToolKit
Quick Start Guide
Contents
1.Overview
2.Package Contents
3.Adjusting the Stand Height
4.Setting up the Measuring Base Station
5.Setting up the Measuring Handset
6.Using the Measuring Handset
7.Configuring the Metering Mode
8.Taking Measurements
www.yealink.com
Overview
The Yealink DECT IP multi-cell deployment toolkit helps you plan and install your DECT IP multi-cell system. It contains one measuring base station, two measuring handsets and further helpful accessories for exact determination of the DECT environmental conditions for the planned network.
You can use the measuring devices in the kit to determine the radio coverage at your location, establish the total number of base stations required for a given installation and their optimal locations, and find sources of interferences in the wireless network.
If you require more information on configuring and using your phone, refer to Yealink DECT IP Multi-Cell System Deployment Guide online:
http://support.yealink.com/documentFront/forwardToDocumentFrontDisplayPage.
Package Contents
DTK |
W56H Handset x 2 |
Battery Cover x 2 |
Rechargeable Battery x 4 |
(Measuring Base Station) |
(Measuring Handsets) |
|
(Two are Reserves) |
USB Charging Cradle x 2 |
|
|
|
Power Adapter x 2 |
Stand |
Base Station Clip |
|||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Mobile Power Clip |
USB-DC Cable |
UH33 Headset x 2 |
Notebook and Pen |
Quick Start Guide |
Note: We recommend that you use the accessories provided or approved by Yealink. The use of unapproved third-party accessories may result in reduced performance.
1
Adjusting the Stand Height
Note: The stand height can be adjusted from 3.28 feet (1.00 meter) to 9.19 feet (2.80 meters).
Setting up the Measuring Base Station
1. Mount the measuring base station on the stand
1 |
2 |
3 |
1Position the thread of the base station clip on the stand and screw the base station clip into place.
2Fix the base station on the base station clip.
Note: To make the base station more secure, make sure the front side of the base station faces to the buckle.
3Adjust the angle of the base station to an appropriate position.
2
Loading...