YAMAHA ENG22 036 Diagram

2007-2008 Yamaha R1

PARTS LIST

1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide

I n s t a l l a t i o n I n s t r u c t i o n s

2 Power Commander Decals
2 Dynojet Decals
2 Velcro
1 Alcohol swab
1 Posi-tap

THE IGNITION MUST BE TURNED

OFF BEFORE INSTALLATION!

YOU CAN ALSO DOWNLOAD THE

POWER COMMANDER SOFTWARE AND

LATEST MAPS FROM OUR WEB SITE AT:

www.powercommander.com

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com

2007-2008 Yamaha R1 PCV - 1I22-036 www.powercommander.com

POWER COMMANDER V

INPUT ACCESSORY GUIDE

USB CONNECTION

EXPANSION PORTS 1 & 2

Optional Accessories such as
Color LCD unit or Auto tune kit.

CRANK

ANALOG

SPEED

SHIFTER

SHIFTER

MAP

MAP

ACCESSORY INPUTS

Map - The PCV has the ability to hold 2 different

base maps. You can switch on the fly
between these two base maps when you hook
up a switch to the MAP inputs. You can use
any open/close type switch. The polarity of
the wires is not important. When using the
Autotune kit one position will hold a base map
and the other position will let you activate the
learning mode. When the switch is “CLOSED”
Autotune will be activated.

Shifter- These inputs are for use with the Dynojet

quickshifter. Insert the wires from the Dynojet
quickshifter into the SHIFTER inputs. The
polarity of the wires is not important.

Speed- If your application has a speed sensor then

you can tap into the signal side of the sensor
and run a wire into this input. This will allow
you to calculate gear position in the Control
Center Software. Once gear position is setup
you can alter your map based on gear position
and setup gear dependent kill times when
using a quickshifter.

Wire connections:

To input wires into the PCV first remove the rubber
plug on the backside of the unit and loosen the
screw for the corresponding input. Using a 22-24
gauge wire strip about 10mm from its end. Push the
wire into the hole of the PCV until is stops and then
tighten the screw. Make sure to reinstall the rubber
plug.

NOTE: If you tin the wires with solder it will make
inserting them easier.

Analog- This input is for a 0-5v signal such as

engine temp, boost, etc. Once this input
is established you can alter your fuel curve
based on this input in the control center
software.

Crank- Do NOT connect anything to this port unless

instructed to do so by Dynojet. It is used to
transfer crank trigger data from one module to
another.

2007-2008 Yamaha R1 PCV - 2I22-036 www.powercommander.com