XPiQ inc PU110-10-1A, PU110-10A, PU110-12A, PU110-13A, PU110-14A Datasheet

7272

72

DESCRIPTION

The PU110 Series of compact, open PCB constructed AC/DC
power supplies are capable of delivering 110 watts of
continuous power at 25 CFM forced air cooling or 80
watts at convection cooling. They operate at 84 to 264
input voltage without the need of changing a
jumper. All outputs are fully regulated. All
models meet VDE class B and FCC class B
emission limits, and are approved to UL,
CSA, and TUV safety standards.

• UNIVERSAL INPUT

FEATURES

• Approved to UL, CSA, and TUV

safety standards

• Built-in EMI filter

• Small size 7.0” x 4.25” x 1.85”

• 100% burn-in

• Wide input voltage (85-264VAC)

• Input surge current protection

• Output overvoltage/overcurrent protection

OUTPUT VOLTAGE/CURRENT RATINGS CHART

Output #1 Output #2 Output #3 Output #4 Maximum

Output

Model Vnom Imin Imax Tol. Vnom Imin Imax Ipeak

1

Tol. Vnom Imin Imax Tol. Vnom Imin Imax Tol. Power

2

PU110-10-1A 3.3V 0A 22A 3% N/A N/A N/A 110W
PUI10-10A 5V 0A 22A 3% N/A N/A N/A 110W
PUI10-12A 12V 0A 9A 2% N/A N/A N/A 110W
PUI10-13A 15V 0A 7.5A 2% N/A N/A N/A 110W
PU110-14A 24V 0A 4.5A 2% N/A N/A N/A 110W
PU110-16A 30V 0A 3.6A 2% N/A N/A N/A 110W
PU110-23A +5V 0A 10A 3% +12V 0A 5A 9A 3% N/A N/A 110W
PU110-31A +5V 0A 10A 3% +12V 0A 5A 9A 3% -12V 0A 1A 4% N/A 110W
PU110-32A +5V 0A 10A 3% +15V 0A 4A 7.5A 3% -15V 0A 1A 4% N/A 110W
PU110-40A +5V 0A 10A 3% +12V 0A 5A 9A 3% -12V 0A 1A 4% -5V 0A 1A 4% 110W
PU110-42A +5V 0A 10A 3% +12V 0A 5A 9A 3% -12V 0A 1A 4% +12V 0A 1A 4% 110W
PU110-45A +5V 0A 10A 3% +12V 0A 5A 9A 3% -12V 0A 1A 4% +24V 0A 1A 4% 110W
PU110-45-1A +5V 1.5A 10A 3% +12V 0A 5A 9A 3% -12V 0A 1A 4% +24V 1.5A 3A 10% 110W
PU110-45-2A +5V 0A 10A 3% +24V 0A 3A 5A 3% -12V 0A 1A 4% +12V 0A 1A 4% 110W
PU110-46A +5V 0A 10A 3% +15V 0A 4A 7.5A 3% -15V 0A 1A 4% -5V 0A 1A 4% 110W

NOTE: (1) Peak output current with 10% maximum duty cycle for less than 60 seconds. Total peak power must not exceed 110 watts.

(2) 110 watts maximum at 25 CFM forced air cooling or 80 watts maximum at convection cooling.

International Power Sources, Inc.

110 WATT

SWITCHING

POWER SUPPLY

Rev A Aug 2002

7373

73

GENERAL SPECIFICATIONS

All specifications are typical at nominal line, full load, and 25°C.

Efficiency: 65% minimum at 110W output
Hold-up time: 12 msec minimum
Line regulation: ±0.5% maximum at full load
Inrush current: 15 amps @ 115 VAC, or

30 amps @ 230 VAC at 25°C
cold start

Withstand voltage: 3000 VAC from input to output

1500 VAC from input to ground

Insulation resistance: 10 Mohm minimum from output

to ground
Operating temperature: 0 to 70°C*
Storage temperature: -40 to +85°C
Mean time between 100,000 hours at full load
failure: at 25°C ambient
EMI requirements: Meets conduction limits of

a) FCC 20780 Level B

b) CISPR 22 (EN 55022) Level B
Safety requirements: Meets or exceeds:

a) UL 1950

b) CSA C22.2 No. 234

c) IEC 950

INPUT SPECIFICATIONS

Input voltage: 85 to 264 VAC/115-370VDC

Input frequency: 47 to 440 Hz

Input current: 3.2A (rms) for 115 VAC

1.8A (rms) for 230 VAC

OUTPUT SPECIFICATIONS

Output voltage: See Rating Charts
Output current: See Rating Charts
Output power range: 0 to 110 watts at 25 CFM forced

air cooling, or 0 to 80 watts at

convention cooling
Ripple and noise: 1% peak to peak maximum
Overvoltage protection: Provided on output #1 only; set at

112-132% of its nominal

output voltage
Overcurrent protection: All outputs protected to short

circuit conditions
Temperature Coefficient: All outputs ±0.04%/°C maximum

* Derate linearly from 100% load at 50°C to 50% load at 70°C

PIN CHART

MECHANICAL SPECIFICATIONS

NOTE:

1. Dimensions shown in inch (mm)

2. Tolerance 0.02 (0.5) maximum

3. Input connector mates with Molex
housing 09-50-3051 and Molex
2878 series crimp terminal.

4. Output connector mates with Molex
housing 09-50-3131 and Molex
2878 series crimp terminal.

5. Weight 600 grams approx.

Model PIN 1,2,3 4,5 6,7 8,9 10 11 12 13

PU110-10-1A, PU110-10A, PU110-12A,

OUTPUT RETURN RETURN OUTPUT P.F.D. N.C. KEY N.C.

PU110-13A, PU110-14A, UP 110-16A

#1 #1

PU110-23A

OUTPUT COMMON COMMON OUTPUT P.F.D. N.C. KEY N.C.

#1 RETURN RETURN #2

PU110-31A, PU110-32A

OUTPUT COMMON COMMON OUTPUT P.F.D. OUTPUT KEY N.C

#1 RETURN RETURN #2 #3

PU110-40A, PU110-42A, PU110-45A,

OUTPUT COMMON COMMON OUTPUT P.F.D. OUTPUT KEY OUTPUT

PU110-45-1A, PU110-45-2A, PU110-46A

#1 RETURN RETURN #2 #3 S #4

Your Source of Power ...

260 Hopping Brook Road, Holliston, MA 01746

TEL:[phone] FAX:[phone]

http://www.intlpower.com

International

Power Sources, Inc.

Rev A Aug 2002