Xerox DOCUMENT CENTRE 230 User Manual

The Document Company

XEROX

DC220/230ST Token Ring® Quick Install

Installation Requirements:

The Token Ring card must be inserted face

down to obtain connectivity.

1. Perform the following procedure if Token

Ring will be selected as the Interface for the network:

a) Press the [Access] button on the

Control Panel.

b) Enter the System Administrator

password by typing #22222 (# key and 22222) on the keypad and pressing [Enter] on the screen.

Note:#22222 is the factory default password and may be changed by your Xerox service representative to suit your needs.

c) On the screen display, press [Print

Setups].

d) Press [Port Setups].

f) Press [Enablement]. g) Press [Enabled]. h) Press [Source Routing] and select

either [All], [Single], or [None].

i) Press [Speed] and select either

[Auto], [4 Mbps] or [16 Mbps].

j) Press [Save]. k) Press [Close]. The DC220/230 will

reboot and print a configuration sheet in approximately 3 minutes.

2. Check the settings on the configuration

sheet against those that were entered.

3. Refer to the Quick Install card for your

environment and perform the network installation at the DC220/230.

Additional information on Token Ring installation can be found in the DC220/230 System Admin- istration Guide.

e) Press [Token Ring].

For assistance, contact your local Xerox Customer Support Center: USA: 1-800-821-2797 Canada: 1-800-939-3769