Xerox DC220, DC230ST User Manual

The Document Company

XEROX

DC220/230ST AppleTalk® Quick Install

Before Installation:

Record the following information for use during setup at the DC220/230:

AppleTalk Printer Name: ______________________________________ Note:The DC220/230 will attach itself to the

default zone of the local segment where it is connected.

1. Connect the DC220/230 to your network

outlet or cable.

2. Enter System Administrator Setups:

a) Press the [Access] button on the

Control Panel.

b) Enter the System Administrator

password by typing #22222 (# key and 22222) on the keypad and pressing [Enter] on the screen.

Note: #22222 is the factory default password and may be changed by your Xerox service representative to suit your needs.

3. Access the AppleTalk Setup screens:

a) On the screen display, press [Print

Setups].

b) Press [Network Setups]. c) Press [AppleTalk].

4. Enable AppleTalk:

a) Press [Enablement]. b) Press [Enabled]. c) Press [Printer Name], then press

[Edit] and use the keyboard displayed on the screen to enter the Printer Name for your network (31 characters, or less).

5. Press [Save].

6. Press [Save].

7. Press [Exit]. The DC220/230 will reboot

and print a configuration sheet in approximately 3 minutes.

8. Check the settings on the configuration

sheet against those that were entered.

9. To install the DC220/230 Macintosh

PPD:

a) Copy the DC220/230 Macintosh PPD

from the CentreWare® CD to the

System Folder/Extensions/Printer Descriptions folder.

b) Set up and configure the Print Driver

via the Chooser.

c) Refer to the CentreWare

Getting Started with Print and Fax Services for additional information.

Additional information on the AppleTalk installation can be found in the DC220/230 System Administration Guide.

manual,

For assistance, contact your local Xerox Customer Support Center: USA: 1-800-821-2797 Canada: 1-800-939-3769