Wolf P1363418, P1423418, P1543418, P1663418 Owner's Manual
I NSTALLATION I NSTRUCTIONS
P RO I SLAND V ENTILATION H OODS
As you follow these instructions, you will
notice WARNING and CAUTION symbols.
This blocked information is important for the
safe and efficient installation of Wolf equipment. There are two types of potential
hazards that may occur during installation.
Another footnote we would like to identify is
IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation.
signals a situation where minor injury or
product damage may occur if you do not
follow instructions.
states a hazard that may cause serious
injury or death if precautions are not
followed.
WOLF®is a registered trademark of Wolf Appliance Company, LLC
CONTACT
INFORMATION
Wolf Customer
Service:
800-332-9513
Website:
wolfappliance.com
3
INSTALLATION REQUIREMENTS
IMPORTANT NOTE:
This installation must be
completed by a qualified installer or Wolf
authorized service center technician.
Installer:
Please read the entire Installation
Instructions prior to installation. Save these
instructions for the local inspector’s reference, then leave them with the homeowner.
Homeowner:
Please read and keep these
instructions for future reference and be sure
to read the entire Use & Care Information
prior to use.
Any questions or problems about the
installation should be directed to your Wolf
dealer or Wolf Appliance Company, LLC at
800-332-9513. You can also visit our website
at wolfappliance.com.
IMPORTANT NOTE:
This appliance must be
installed in accordance with National Electrical
Codes, as well as all state, municipal and local
codes. The correct voltage, frequency and
amperage must be supplied to the appliance
from a dedicated, grounded circuit which is
protected by a properly sized circuit breaker or
time delay fuse. The proper voltage, frequency,
and amperage ratings are listed on the product
rating plate.
Record the model and serial numbers before
installing the Pro island ventilation hood. Both
numbers are listed on the rating plate, located
on the left wall of the hood shell.
WOLF PRO ISLAND VENTILATION HOODS
Island Hood
Island Hood
(R) Rail Option
Dimensions in parentheses are in
millimeters unless otherwise specified.
LIST OF MATERIALS
The following is a list of materials shipped
with the Wolf Pro island ventilation hood.
Stainless steel island hood
Transition with backdraft damper (attached
inside hood—needs to be removed)
Decorative stainless steel rails and installation components—(R) model hoods only
Two control knobs
Filters and grease cups (installed in hood)
(8–16) #10 x 2" (51) self-tapping hex head
screws (number of screws varies with the
width of the island hood)
(4)
1
/4" x 3" (76) lag screws
Installation package (taped to filters)
Installation Instructions
Use & Care Information and product
registration card
Wolf logo nameplate
Rating plate location
Location of rating plate
inside left wall
Model Number
Serial Number
4
WOLF PRO ISLAND VENTILATION HOODS
IMPORTANT NOTE:
Wolf recommends that
the Pro island ventilation hood be installed
30" (762) to 36" (914) above the countertop.
Rail option (R) island hoods come with classic
stainless steel decorative rails and stand-offs
on both sides of the hood. Optional platinum
or brass rails are available to match Wolf dual
fuel range bezels. Contact your Wolf dealer for
details.
ELECTRICAL REQUIREMENTS
Wolf Pro island ventilation hoods require a
separate, grounded 110/120 V AC, 60 Hz power
supply. The service should have its own 15
amp circuit breaker. Locate the electrical
supply through the top of the hood. Refer to
the Installation Specifications illustration on
the following page.
You must follow all National Electrical Code
regulations. In addition, be aware of local
codes and ordinances when installing your
service.
DUCT COVER
If you are installing a Wolf duct cover with the
Pro island hood, refer to instructions on page 8
before installing the hood.
ACCESSORIES
Optional accessories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
INSTALLATION CONSIDERATIONS
IMPORTANT NOTE:
Wolf Pro island ventilation hoods are recommended for use with all
Wolf cooking appliances.
Proper installation is the responsibility
of the installer. Product failure due to
improper installation is not covered
under the Wolf Warranty. Refer to the Wolf
Pro Ventilation Hoods Use & Care
Information for warranty details, or visit
the Contact/ Help section of our website,
wolfappliance.com.
Make sure you have the tools and materials
necessary for proper installation.
Warranty service must be performed by a
Wolf authorized service center. Wolf is not
responsible for service required to correct a
faulty installation.
IMPORTANT NOTE:
Wolf Pro ventilation
hoods are shipped without the blower
assembly. Wolf internal, in-line and remote
blower assemblies are available; refer to pages
13–15. Use only a Wolf blower with the Pro
island hood.
5
Dimensions in parentheses are in
millimeters unless otherwise specified.
INSTALLATION INSTRUCTIONS
TOP WIDTH
SUBTRACT 18" (457) FROM OVERALL WIDTH
18" (457)
OVERALL
HEIGHT
OVERALL WIDTH
34" (864)
OVERALL DEPTH
13"
(330)
4"(102)
2"
(51)
3
/4" (19)
DIAMETER
OF RAIL
2"
(51)
OVERALL DIMENSIONS
PRO ISLAND HOODS
Overall Widths 36" (914), 42" (1067),
54" (1372) and 66" (1676)
Overall Height
18" (457)
Overall Depth (
excluding
rails) 34" (864)
Shipping Weight (shell only) 95–168 lbs
(43–76 kg)
Dimensions may vary to ±1/8" (3).
Pro Island Hood
18" (457)
HEIGHT
OF HOOD
34" (864)
DEPTH OF HOOD
WIDTH OF HOOD
LOCATION OF ELECTRICAL SUPPLY
CENTERED THROUGH TOP OF HOOD
30" TO 36"
(762–914)
TO COUNTERTOP
30" TO 36"
(762–914)
TO COUNTERTOP
INSTALLATION SPECIFICATIONS
Pro Island Hood
6
WOLF PRO ISLAND VENTILATION HOODS
INSTALLATION SPECIFICATIONS
The illustration and chart below provides
dimensions critical for proper installation of
the Wolf Pro island ventilation hood.
34" (864)
DEPTH OF
HOOD
A
WIDTH OF
HOOD
B
WIDTH OF
TOP PLATE
C
HEIGHT OF
TRANSITION
D
TO CENTER
OF TRANSITION
6
1
/2
"
(165)
13"
(330)
10" (254)
Pro Island Hoods
Model (A) (B) (C) (D)
I363418 36" (914) 18" (457) 83/4" (222) 9" (228)
I423418 42" (1066) 24" (610) 83/4" (222) 12" (304)
I543418 54" (1371) 36" (914) 83/4" (222) 18" (457)
I663418 66" (1676) 48" (1219) 83/4" (222) 24" (610)
Letters correspond to those in the illustration.
To reduce the risk of fire and electric
shock, install this ventilation hood only
with a blower manufactured by Wolf.
Blower model numbers are listed on
page 17.
Loading...