Coffee System Quick Start Guide
To Make Coffee
WHOLE BEANS
Do not use oily, caramelized or avored beans.
1 Press multiple times to select the desired taste.
• Extra-Mild
• Mild
• Standard
• Strong
• Extra-Strong
2 Press multiple times to select the desired volume.
• Espresso (1 oz)
• Short Coffee (3 oz)
• Coffee (9 oz)
• Long Coffee (12 oz)
3 Press to initiate the cycle or press to double
the volume and initiate the cycle.
For all beverages 12 oz
BEANS, EMPTY TRAY AND GROUNDS’ will appear on the
display. Once levels have been veried, press
the cycle.
PRE-GROUND COFFEE
1 Press multiple times and select pre-ground.
2 Press multiple times to select the desired volume.
3 Press to initiate the cycle or press to double
the volume and initiate the cycle.
(360 ml) or larger, ‘FILL WATER AND
to initiate
To Make Cappuccino
1 Adjust the froth regulator on the milk container.
2 Fill and insert the milk container.
3 Place a cup under the spout, then verify the milk spout is
positioned over the cup.
4 Press to initiate the cycle.
5 Once the cycle is complete, place a cup under the milk
spout, then press and hold CLEAN on the milk container
to clean the milk spout.
To Make Latte Macchiato, Caffelatte, Frothed Milk
1 Adjust the froth regulator on the milk container.
2 Fill and insert the milk container.
3 Place a cup under the spout, then verify the milk spout is
positioned over the cup.
4 Press , press or to scroll to desired beverage, then
press
5 Once the cycle is complete, place a cup under the milk
spout, then press and hold CLEAN on the milk container
to clean the milk spout.
to initiate the cycle.
RECEPTACLE
WHOLE BEANS
Whole bean compartment.
PRE-GROUND COFFEE
Pre-ground compartment.
FROTH
REGULATOR
Froth regulator.
CLEAN
BUTTON
Milk container.
Coffee System Quick Start Guide
MILK
SPOUT
INTAKE
TUBE
FROTH
REGULATOR
CLEAN
Cup Placement
The adjustable height coffee spout has two outlets. One or
two cups can be placed under the spout. Adjust the height of
the spout as close to the cup(s) as possible.
One cup.
Two cups.
Care Recommendations
CLEANING
• ‘EMPTY GROUNDS CONTAINER’ is displayed when the
grounds container is full or if the grounds container has
not been emptied for approximately three days. To access
the grounds container, open the service door. Slide the
drip tray forward to remove. Refer to the illustration below.
• The milk container lid can be disassembled for cleaning.
Refer to the illustration below.
CLEAN
INTAKE
TUBE
FROTH
REGULATOR
DRIP TRAY
GROUNDS
CONTAINER
Service door open.
INFUSER
MILK
SPOUT
Milk container lid.
• Clean the infuser at least once a month. Turn the unit
off, then open the service door and remove the drip tray
and grounds container. Press the two red buttons inward
and remove the infuser. Soak in water approximately ve
minutes, then rinse and towel dry. Do not use detergent.
Replace by sliding the infuser onto the internal support
and bottom pin, then press ‘PUSH’ until it clicks into
place. Verify the red buttons have snapped out.
IMPORTANT NOTE: Do not use detergent to clean the
infuser. It will remove lubricant on interior parts.
DESCALE
Use only EcoDecalk descaling solution.
1 Remove the water tank and empty completely.
2 Fill the tank half full with water then add entire descaler
contents. Reinstall the water tank.
3 Install the water spout, then place a large container, more
than 50 oz
4 When the appliance is on, press to access options.
5 Press or until ‘DESCALE’ is displayed, then
press
(2 L), under the spout.
. ‘DESCALING UNDERWAY’ will appear on the
display.
6 After 30 minutes, ‘RINSING FILL TANK’ is displayed.
Fill the water tank with water and empty the large container, then reinstall.
7 Press . ‘RINSING PLEASE WAIT’ will appear on the
display.
8 Once the cycle is complete, ‘RINSING COMPLETE’ will
appear on the display, then ll container and press
Press
and then press .
.
9002412 REV-A 9/2014
WOLF APPLIANCE, INC. P.O. BOX 44848 MADISON, WI 53744 WOLFAPPLIANCE.COM 800.222.7820