Wolf 817992 Installation manual

817992

E-Series / Microwave Trim Kit

818125 / Rev A / November, 2010

INSTALLA

TION PROCEDURE:

Cabinet Opening Preparations and Installation of Mounting Brackets

1. Locate properly grounded 3-prong receptacle within 4” (102mm) from the right side and 4” (102mm) up from bottom of microwave oven cabinet.

Install the MW24 with a 120V, 60Hz, on a dedicated circuit. This outlet must be checked by a qualified electrician to see if it is wired with correct polarity and is correctly grounded. A GFCI outlet is not recommended as this may cause product operation interruptions.

2. Floor of opening should be constructed of plywood strong enough to support weight of oven (about 100lbs/.45kg). Floor should be level for proper operation of oven. Check local building code as it may require the opening be enclosed with sides, ceiling and rear partition. Proper functioning of oven does not require this enclosure.

Bottom Duct, Microwave & Decorative Trim Install

1. Center bottom duct assembly in the opening. Secure assembly to base of cabinet opening, using #8-15x1/2'' truss head screws (See Figure

1).

2. Plug power cord in. Carefully guide microwave into opening, lining up feet of microwave with holes in bottom duct assembly. NOTE: Verify

that power cord is not pinched between microwave oven and wall. Then lower microwave

onto bottom duct assembly (See Figure 1).

3. Attach frame assembly directly to cabinet, using four #6-18x1'' wood screws. NOTE: Always pre-

drill a pilot hole before installing screws to avoid damage to cabinet or trim kit hardware.

4. Adhere decorative trim panels to side brackets, so they are tight to the side and bottom of the frame assembly (See Figures 2). NOTE: The two

pieces of foam tape are to be used if gaps appear between the frame and microwave perimeter. If gaps are present, remove the trim and adhere the foam tape to the microwave where needed.

QTY

DESCRIPTION

1 Frame Assembly 6 Screw, 6-18x1'' TPG Type A 2 Screw, #8-15x1/2’’ Truss HD 2 Large Glass Trim

QTY

DESCRIPTION

1 Bottom Ductwork MW24 2 Large Foam 2 Small Foam 1 Instructions

E-Series MW24

CONT

AINS:

Page 1 of 1

Figure 2. Decorative Trim / Unframed Assembly

Large Glass

Decorative Trim

NOTE: Once installed, trim will sit tight to side and bottom of frame assembly

Figure 1. Microwave Install in Cabinet Opening

Btm

Duct

Mounting

Screws

The feet of the microwave will sit in these holes.

Frame

Assembly