Page 1
INDOOR FLUSH MOUNT
User Manual
SHD-315F
Page 2
INDOOR FLUSH MOUNT
User Manual
Copyright
©2020
Hanwha Techwin America, All rights reserved.
Trademark
Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the
registered trademark of their respective company.
Restriction
Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed,
partially or wholly, without formal authorization.
Disclaimer
Hanwha Techwin America makes the best to verify the integrity and correctness of the contents in this document, but no
formal guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own
responsibility. Hanwha Techwin America reserves the right to change the contents of this document without prior notice.
Design and specifications are subject to change without prior notice.
Page 3
Introduction
PRODUCT OVERVIEW
y
The SHD-315F Kit provides an economical integrated solution for indoor suspended ceiling applications
for the PNM-9084RQZ & PNM-9085RQZ cameras.
Contents
COMPONENT LIST [FIGURE 1]
A. Safety Tether (4)
B. Ceiling Tile Support Plate
C. 8-32 x 5/16” Pan Head Screws (4)
D. Ceiling Tile Insert
A
D
B
C
Page 4
INSTALLATION
•
Remove existing ceiling tile from desired mounting location.
•
Attach Ceiling Tile Support Plate (B) to ceiling tile grid. The tabs will slip
down over the grid edge as seen in [FIGURE 2].
•
Attach the 4 safety tethers (A) to the red iron, as seen in [FIGURE 3] by
threading the end of the tether through the looped end.
Make multiple wraps around the red iron to make sure there is no slack in the
tethers.
FIGURE 3
FIGURE 2
Thread end of tether through
looped end.
Page 5
INSTALLATION
•
Mount the camera onto the Ceiling Tile Support Plate (B) using the included #8-32 x 5/16” screws (C).
(See Camera Installation Instructions). [FIGURE 3]
•
Make camera power and network connections.
•
Lift camera/bracket assembly back off of the grid and drop in the ceiling tile insert (D) in [FIGURE 4], then replace
assembly back on to the grid as shown in [FIGURE 5].
B
C
B
FIGURE 3
FIGURE 5
MECHANICAL PROPERTIES
MECHANICAL PROPERTIES
•
Support unit: Steel
•
Lower unit: ABS
•
Unit weight: 7.3 lbs w/o camera
FIGURE 4
D
ENVIRONMENT
•
Indoor
Page 6
Hanwha Techwin America
500 Frank W. Burr Blvd. Suite 43 Teaneck, NJ 07666
Toll Free +1.877.213.1222 Direct +1.201.325.6920
Fax +1.201.373.0124
www.hanwhasecurity.com
Loading...