Whirlpool HB 560 S PROGRAM CHART

HB 560
HOB INSTRUCTIONS Destination
GB
HU
2
1
3
6 7 8 9
10
Removable panstand grids
1.
Medium burners
2-3.
Large burner
4.
Small burner
5.
Medium burner control knob
6.
Medium burner control knob
7.
Large burner control knob
8.
Small burner control knob
9.
Electric ignition button
10.
Symbols
Shaded circle Tap closed
4
5
Large flame Maximum opening/delivery
Small flame
HOB DIMENSIONS (mm)
To light one of the burners:
Press the relative knob and turn it anti-clockwise to the large flame setting .
At the same time, press the button with the star . The spark plug gives out a spark that causes the burner to ignite.
Once the burner is lit, keep the knob pressed for about 10 seconds.
Release the knob.
If the burner does not ignite, repeat the operation.
Note:
Should particular local conditions of the delivered gas
-
make the ignition of the burner difficult, it is advisable to repeat the operation with the knob turned to the small flame setting .
The burner safety system serves to prevent the emission of gas if the flame should be extinguished accidentally (draughts, interruptions in gas supply, dousing with liquids, etc.).
Minimum opening or reduced delivery
INJECTORS TABLE CATEGORY II2HS3B/P
Type of gas used Type of
NATURAL GAS (Methane) G20
NATURAL GAS G25.1
LIQUID PETROLEUM GAS (Butane) G30 (Propane) G31
Type of gas used Appliance model Total rated heat
G20 25 mbar 4 gas 7.30 695 l/h 9.52 G25.1 25 mbar 4 gas 7.30 809 l/h 8.19 G30/G31 30 mbar 4 gas 7.30 531 g/h 30.95
burner
large medium small
large medium small
large medium small
Injector marking
F3 117
F3 87
X 68
F2 125
F2 96
5-77
87 65 50
Rated heat capacity kW
3.00
1.65
1.00
3.00
1.65
1.00
3.00
1.65
1.00
capacity kW
Rated consumption
286 l/h 157 l/h
95 l/h
332 l/h 183 l/h 111 l/h
218 g/h 120 g/h
73 g/h
Total rated consumption
Reduced heat capacity kW
0.70
0.40
0.35
0.60
0.35
0.30
0.60
0.35
0.30
Gas pressure (
min. rat. max.
20 25 33
18 25 33
25 30 35
Air necessary (m combustion of 1 m
mbar)
3
) for the
3
of gas
ELECTRIC SUPPLY: 230V ~ 50Hz
BEFORE USING THE COOKTOP
These instructions are only valid for above mentioned Country destinations and also on the appliance.
Keep the packaging material (plastic bags, polystyrene
parts, etc.) out of the reach of children, as they are potentially dangerous.
Use a proprietary detergent to clean the stainless steel hob
and remove any grease and food deposits. Before using the hob, be sure to remove any adhesive labels.
Check whether the cooktop has been damaged during
transport.
Ensure that the installation and gas/electrical connections are performed by a qualified technician, following the manufacturer's instructions and in compliance with current local safety regulations.
NOTES: In case of installation of a hood above the cooktop, please refer to the hood instructions for
the correct distance.
5019 619 01123/A
To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.
SUGGESTIONS FOR ENVIRONMENT PROTECTION
Packing
The packaging material is 100% recyclable and marked with the recycling symbol ( ).
Products
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health.
The symbol on the appliance or accompanying documentation indicates that this product should not be disposed of as unsorted municipal waste but must be taken to a collection point for the treatment of WEEE. Dispose of in accordance with local standards governing waste disposal.
For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance.
PRECAUTIONS AND GENERAL ADVICE
CARE AND MAINTENANCE
Before any cleaning or maintenance operation, disconnect the cooktop from mains power supply.
The use of a gas appliance produces heat and humidity in the room. Ensure that the room is well ventilated, or install an extractor hood with exhaust duct.
In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood).
Keep children away from the cooktop when it is in use and when its has just been switched off.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety.
After use, ensure that the knobs are in position (off), and close the main gas delivery valve or the gas cylinder valve.
Caution: the lid (where present) might break if overheated. Before closing it, make sure that all the burners are off.
Warning: The protective rubber feet on the panstand grids represent a choking hazard for young children. After cleaning the panstand grids, please ensure that all the rubber feet are correctly fitted.
Declaration of conformity
This cooktop has been designed, constructed and marketed in compliance with:
- safety requirements of EEC Directive “Gas” 90/396;
- safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments).
- protection requirements of EEC Directive “EMC” 89/336;
- requirements of EEC Directive 93/68.
This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. 1935/2004.
This cooktop (Class 3) has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous.
Cleaning the cooktop surface, panstand grids and control panel
Before cleaning the cooktop, disconnect it from mains power supply and wait until it has cooled down.
Wipe with a cloth moistened with hot water and soap or
diluted liquid detergent. Do not use abrasive or corrosive products, chlorine
products or steel wool. Do not use vapour cleaning appliances.
Do not use flammable products.
Do not leave acid or alkaline substances, such as vinegar,
salt or lemon juice, etc., on the cooktop.
Stainless steel surface
Clean with a specific commercial product.
Note: if the cooktop is used continuously, the high temperatures produced by the flames may alter the colour of the surface near the burners.
Cleaning the burners
Raise the cap and remove it.
1.
Extract the burner from its housing by pulling it up.
2.
Soak the burner and the cap in hot water and liquid
3.
detergent. (Do not wash into a dishwasher). Rinse out and dry carefully.
4.
Ensure that none of its openings is clogged.
5.
Reposition the burner and cap.
6.
Note: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing.
Cleaning the electric hotplate
The electric hotplate must be cleaned when it is lukewarm.
Wipe with a cloth moistened with water and salt, and polish with a cloth moistened with oil.
ENERGY SAVING TIPS
The cooktop is equipped with burners and/or a hotplate
with different diameters. Use pots and pans whose bottom diameter is equal to that of the burners and hotplate, or slightly larger. Only use flat-bottomed pots and pans.
The pots and pans must not overlap the control panel.
Burner Diameter of container
Large (9,1 cm) Medium (6,4 cm) Small (4,5 cm) Triple crown (12 cm) Fish kettle (23 cm x 4,5 cm)
24 to 26 cm 16 to 22 cm 8 to 14 cm 24 to 26 cm 16 to 35 cm
If possible, keep the container covered when cooking.
Cook vegetables, potatoes, etc. with a small amount of
water in order to cut down cooking time. A pressure cooker allows you to save even more energy
and time.
NO!
TROUBLESHOOTING GUIDE
1. The burner fails to ignite:
Is the main gas delivery valve open?
Has the delivery of the town gas (methane) been suspended?
Is the gas cylinder (liquid gas) empty?
Are the openings of the burner clogged?
Have the cap and burner been positioned correctly after
cleaning? (See paragraph “Care and Maintenance”.)
AFTER SALES SERVICE
Before you call the After Sales Service:
Check the “Troubleshooting guide” above to see if you
1.
can eliminate the trouble yourself. Re-start the cooktop, to check whether correct operation
2.
has been restored. If the malfunction persists, call the After Sales Service.
3.
Give the following information:
type of malfunction;
model of cooktop;
service number (i.e., the number that follows the word
SERVICE on the rating plate under the cooktop and on the guarantee paper); your complete address;
your telephone number and area code.
2. The burner fails to remain lit:
Repeat the ignition operation, turning the knob to the
position with the small flame symbol .
3. The electric ignition device does not work:
Is there a power failure?
If any repairs are required, please contact
After-Sales Service,
In the unlikely event that an operation or repair is carried out by an
unauthorised technician,
certification of the job carried out and insist on the use of
original spare parts Failure to comply with these instructions may
compromise the safety and quality of the product.
as indicated in the warranty.
.
an authorised
always request a
Loading...
+ 2 hidden pages