Before using the dishwasher, read the user instructions!
GSXK 7415 |
Quick Reference Guide |
GB |
||
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme.
|
Programme chart |
|
Detergent 2) |
Consumption 3) |
|||||
|
|
|
|
|
|
|
|
|
|
|
Programmes |
|
Loading instructions |
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
|
|
|
|
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
5.0 |
0.02 |
10 |
|
|
|
|
|
|
|
|
|
|
|
|
Quickwash |
40°C |
Lightly soiled crockery with no |
X |
- |
13.0 |
0.70 |
30 |
|
|
|
|
dried-on food. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio 1) 4) |
50°C |
Normally soiled crockery. |
X |
X |
16.0 |
1.05 |
195 |
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
|
Intensive |
70°C |
Heavily soiled crockery, especially |
X |
X |
17.0 |
1.65 |
145 |
|
|
|
|
pots and pans. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1) Reference programme for energy label EN 50242; |
3) Programme data obtained in conformity with European |
||||||||
2) Refer to “User instructions”; |
|
|
standard EN 50242. Values may vary in relation to usage, |
||||||
|
|
|
|
e.g.: different loads, options, water temperatures - above |
or below 15°C - as well as water hardness and power supply voltage, etc.
4) Energy saving programme with prolonged drying cycle.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
5019 496 90466
(We reserve the right to make technical modifications)
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door, switch on the appliance
How to fill the detergent dispenser
Check the rinse aid level
Check the regeneration salt level
Load the racks
Select a programme
Select options
Press the Start button
Turn on the water tap close the dishwasher door
Press the ON button.
Compartment A:
With each wash cycle.
A B C
Compartment B:
For programmes with pre-wash only.
If using combined action dishwasher tabs, follow the user instructions!
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D. Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is |
“Change programme” |
||
|
|
Press the START button for 2 sec. until |
|
|
|||
then memorised (even in the |
|
|
the Start indicator lamp switches off; |
event of power failure). |
|
|
Select another programme and press |
|
|
|
|
|
|
|
the START button again. |
|
|
|
|
Wash cycle
Switch off the appliance
Turn off the water tap, unload the racks
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a
wash cycle, when switched on again it will resume the cycle from where it was interrupted.
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.