Whirlpool GSF 5988 WS INSTRUCTION FOR USE
5019 496 90287
GB
GSF 5988
Quick Reference Guide
Before using the dishwasher, read the user instructions!
BK/I/B/GB
(We reserve the right to make techni cal modifications)
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Time and failure display
3)
Indicates in hours the time remaining until
the start of the wash cycle. Switches off when
the programme has started and indicates the
time remaining in hours and minutes.
“F...” Information for the After-Sales
Service
“Delayed start” button
The wash cycle can be programmed to start
after 1 - 24 hours. With each successive touch
of the button, the delayed start indicator
increases by 1 hour, and after 24 returns to
00.Then press the Start button. The
dishwasher will start at the set time.
“Half Load” button
This function can be used with any
programme. The indicator lam p switches on.
The wash cycle is activated for the upper or
lower rack only.
1) Reference program me for energy label in
compliance with EN 50242 regulations;
2) Refer to “Us er instructions“;
3) Program data obtained in conformity wit h
European standard EN 50242. Values may vary in
relation to usage, e. g. : different loads, water
temperatures - above or below 15°C - as we ll as
water hardness and power supply voltage, etc.
Programme selector knob
On/Off button
Start button
Switches “on” when the dishwasher
is operating. Flashes when a fault
occurs. Switches off at the end of
the programme.
Indicators
Wash cycle
Pre-Rinse Washing Drying
Programme
end
Options
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B
Litres kWh Minutes
AutoNormal 40-55°C
Automatic programme rec om mend ed f or
routine washes, with n o drie d-on or burnt
food (not for EN 50242).
X X 10-13 0.8-1.05 50-110
AutoIntensive 60-70°C
Automatic programme rec om mend ed f or
heavily soiled crocke ry w ith d ri ed-o n or
burnt food, for example pans and saucepans.
X X 13-20 1.1-2.0 90-140
Pre-Rinse cold
Crockery to be washed later. - - 4.0 0.03 14
Glass 40°C
Light soiling, for exa mple glasses and cups. X - 10.0 0.80 55
Rapid 30 min 40°C
Lightly soiled crockery with no
dried-on food.
X - 10.0 0.65 30
Standard
1)
50°C
Normally or heavily soi led crockery. X X 13.0 1.05 120
Important information for Test Labo ratories:
For detailed information on the EN/Stand ard loading compariso n test, contact the following address:
“nk_customer@email.whirlpool.com”.
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
/ OFF button.
Large compartment
A:
With each wash cycle.
Small compartment
B:
For programmes with pre-wash only.
Mechanical indicator lamp
C
.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator lamp
D
.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
Only after the START button has switched off: Press the
ON /
OFF
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
How to fill the
detergent dispenser
C
BA
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Select additional
options
Press the START button
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
Loading...