Whirlpool GSF 5544 TW-WS INSTRUCTION FOR USE

GB GSF 5544

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Programme progress indicator

Rinse aid level indicator

Pre-rinse / Pre-wash

Drying

Start button

Add rinse aid.

Washing

Programme end

Indicator lamp lit while the

Salt level indicator

dishwasher is operating.

Add regeneration salt; only add

Options

Flashes when a fault occurs.

regeneration salt immediately

Switches off at the end of the

before starting a wash

Delayed start buttons

programme.

The wash cycle can be programmed to start after 1-24 hours.

On / Off Button

Then press the Start button. The dishwasher will start at the set time.

Time and failure display

Indicates in hours the time remaining until the start of the wash cycle.

Switches off when the programme has started.

Toward the end of the programme, during the drying cycle,

the display will indicate the time remaining in minutes.

“F1--F9” Identification of faults for service technician.

Place the detergent in the:

Consumption

small

large

Programme Symbol

Programme selection and

Normal load

compartment

and Temperature

recommended load type

Water

Energy

Time

(Litres)

(kWh)

(Min.)

Pre-wash

Crockery to be washed later.

5.0

0.02

Rapid 40° C

Lightly soiled crockery with no dried-on food.

13.0

0.85

Bio-Normal 50° C 2)

Normally or heavily soiled crockery with dried-on food.

16.0

1.05

120

Normal 65° C 3)

Normally or heavily soiled crockery with dried-on food.

16.0

1.60

1)Values may vary in relation to usage, e.g.: different loads, water

temperatures - (above or below 15° C -, water hardness and power supply voltage, etc.

2)Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme on the energy data plate.

3)Programme recommended when using detergents of type A (non enzyme-based detergents).

5019 100 90332

(We reserve the right to make technical modifications)

Whirlpool GSF 5544 TW-WS INSTRUCTION FOR USE

How to use the dishwasher

Upper and lower rack

1.After loading the dishwasher, close the door properly and open the water supply tap.

2.Press the On/Off button to switch the dishwasher on. One of the programme indicator lamps will switch on.

3.Select the desired programme by pressing the corresponding button.

The corresponding indicator lamp lights up. If required, select options (if supplied).

4.Press the Start button to start the selected wash programme. The Start indicator lamp will light up. Once set, the programmed data cannot be altered by pressing the programme selector buttons.

Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even

during interruption of the power supply. To change the selected

programme, press the Start button for about 5 seconds, until the Start indicator lamp switches off.

Select a new programme using the programme selector knob and press the Start button.

Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash

cycle and exercise maximum caution. Danger of scalding from steam.

5.To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min.).

6.Once the Start indicator lamp has switched off press the On/Off button to switch the dishwasher off. All the indicator lamps switch off.

7.Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The rack height can also be changed when loaded.

•To lower: pull out the two side handles and gently lower the rack.

•To raise: pull up the two side handles until the rack clicks into place.

•The rack must be level on both sides.

Crockery holders:

•Down: cups and long-stemmed glasses.

•Up: plates.

“Vario Organizer” multi-purpose support:

•To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses.

•May be used in three different positions (see also “Dishwasher loading instructions” on Page 4).

1.Upon the left-hand side of the rack.

2.Upside-down, towards the centre of the rack.

3.Upside-down, towards the left side.

Glass holder:

Lower rack

Plate holders:

•May be lowered to increase available space (A).

•May be removed to increase available space (B). To remove: pull the handle up.

Cutlery basket:

The cutlery basket can be removed to increase (C) available space.

Please read the user instructions carefully.

+ 2 hidden pages