Whirlpool FRUE 3308A, AFG 370/G, AFG 389/H, AFG 365/G/BR Product sheet
40023-gb.fm5 Page 1 Friday, September 10, 2004 3:49 PM
PRODUCT CHART
1. Freezer compartment
2. Control unit
3. Area for drawers and pull out baskets
4. Defrost water run-off channel (extractable)
5. Rating plate (fitted on the inside of the
appliance)
6. Ice packs (inside - if supplied)
Note: drawers and accessories may vary according to the model
Controls (depending on model)
D
B
A
E
C
GB
Storage compartment
Freezer comp artment
F
A Digital temperature indicator.
B Yellow light: indicates that the rapid freeze
function is in operation.
C Red light: flashes to indicate that the
temperature inside the freezer has risen to
unacceptable values.
G
Starting up the freezer
1. Plug in the appliance.
Warning
If the digital indicato r shows only
an illuminated dot, press the
freezer on/off button D.
2. Press button G to mute the
acoustic alarm.
3. Allow the temperature on the
digital indicator display to reach
-12°C.
4. Place the foods to be frozen and/
or those already frozen, in the
freezer
D Freezer on/off button.
E Button for adjusting the interna l temperatur e.
F Rapid freeze button.
G Acoustic alarm mute button.
The digital indicator di splays six
horizontal lines
After about 3 seconds, when the
appliance is warm (internal
temperature greater than 10°C) only
the two lines in the middle remain
illuminated; red light C illuminates
and the acoustic alarm sounds.
The acoustic alarm stops while the
red light continues to flash.
When the temperature reaches
-12°C, the red light automatically
stops flashing.
5019 100 40023
GB INLFD E
P
DKN FINGR S
40023-gb.fm5 Page 2 Friday, September 10, 2004 3:49 PM
PRODUCT CHART
Regulating the temperature inside the freezer
The appliance is normally factory set to operate at the recommended temperature of -18°C.
To vary the internal temperature between -16°C and -24°C :
• Press button E once to adjust the internal temperature: the digital display indicates the
temperatur e set previously .
• Each time the button is pressed, the temperature is modified by 1°C: the value varies cyclically
between -16°C and -24°C.
• Five seconds after the button has been pressed for the last time, the temperature set is stored,
the display stops flashing and the current internal temperature is displayed .
Note:
The digital display displays internal temperature values between +10°C and -24°C.
Selected functions are retained in the memory even during power failures.
Rapid freezing
The rapid freeze function is automatically deactivated after 48 hours.
Alarm indications
Indication Cause Solution
Door open alarm
Temperature
alarm
Temperature
alarm sensor
Prolonged
power failure
alarm
Acoustic alarm activated The door has been left open
The acoustic alarm and
red light C are activated
The acoustic alarm is
activated and the display
shows "SF"
The acoustic alarm and
red light C are activated;
the display flashes
indicating the highest
temperature reached
following the power
failure.
for more than one minute
Internal temperature is
higher than -12°C
Temperature sensor fault Contact Customer
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which proper
food storage cannot be
guaranteed
Shut the door
Press button G and
wait for the
temperature to fall
below -12°C
Service.
Press button G; the
display now indicates
the current internal
temperature.
Note:
The temperature alarm is also activ ated if the doo r is left open fo r a long period or after fresh fo od has
been placed in the freezer compartment; the temporary rise in temperature does not affect perfect
storage of already frozen foods.
Defrosting
1. Press the freezer on/off butto n D. An illuminated dot appears on the digital
display
2. Unplug the ap pliance or disco nnect power
at the mains .
3. Follow the instructions given in the
instruction booklet
4. Plug in the appliance again.
5. Press the freezer on/off butto n D. Follow the procedure for "Starting up the
appliance"
5019 100 40023
GB INLFD E
P
DKN FINGR S
Loading...