41902006GB.fm Page 11 Tuesday, May 9, 2006 11:08 AM
INSTRUCTION FOR USE
BEFORE USING THE GLASS CERAMIC HOB
INSTALLATION ELECTRICAL CONNECTIONS ENERGY SAVING TIPS
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
HOB ACCESSORIES
CARE AND MAINTENANCE OF THE GLASS-CERAMIC HOB
TROUBLESHOOTING GUIDE AFTER SALES SERVICE
11
41902006GB.fm Page 12 Tuesday, May 9, 2006 11:08 AM
BEFORE USING THE GLASS CERAMIC HOB
• To make the most of your new appliance, please read the user instructions carefully and keep them handy for future consultation.
INSTALLATION
Cooktop |
|
|
• The cooktop must be set into a worktop between 20 |
Rear wall |
|
mm and 50 mm deep |
|
|
• There must be nothing between the cooktop and the |
Front |
|
oven (cross rails, brackets, etc.). |
||
|
•The distance between the lower face of the glass ceramic hob and the cupboard or separating panel must be at least 20 mm.
•If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop to the side of the column unit.
•Make an opening in the worktop, respecting the dimensions indicated in the enclosed product description sheet.
•Apply the supplied gasket to the cooktop (unless it has already been fitted), after having cleaned its surface.
Important
In order to prevent the electronic circuits from overheating, and therefore from being damaged, we recommend the following:
•Do not install the cooktop near a dishwasher or washing machine, so that the electronic circuits do not come into contact with steam or moisture, which could damage them.
If an oven (from our range of ovens) is installed beneath the cooktop, make sure that it is equipped with a cooling system.
If the temperature of the electronic circuits exceeds the maximum permitted temperature, the cooktop will switch off automatically; in this case, wait for a few minutes until the internal temperature of the electronic circuits reaches a tolerable level, at which point it will be possible to switch the hob on again.
•Switch the hob off after use.
12
41902006GB.fm Page 13 Tuesday, May 9, 2006 11:08 AM
INSTALLATION
Assembly
A)If the worktop is made of wood, use the appropriate brackets, spring clips and screws provided.
•Position the 4 clips (A) around the cooktop frame, in the slots provided, see Fig. 1
•Measure the centre of the vertical sides of the cut out a
shown in Fig. 2. |
|
|
• Position the centre of the brackets (C) on the centre of the |
Fig. 1 |
A |
side previously identified. |
|
|
|
|
•The upper edge of the brackets must be flush with the worktop surface.
•Secure using the 4 screws (B)provided that should screwed into the pre-prepared holes.
•Insert the cook hob into the pre-prepared hole ensuring that
the clips (A) lodge into the bracket slots provided |
|
Fig. 2 |
(C Fig. 4 e 5). |
|
|
|
C |
|
|
|
|
|
|
|
|
B |
|
|
Fig. 3 |
|
A
Fig. 4
Fig. 5
B)If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc.), the hob must
be fitted by means of brackets code 4819 310 18528. |
|
(to be ordered from After-Sales Service if not provided). |
Top min. 20 mm |
• Fit the hob into the worktop. |
Top max. 50 mm |
|
|
• Position the brackets (C) as shown in the figure, in |
|
accordance with the thickness of the worktop. |
|
• Secure the screws (E) in holes (D). |
|
13
Loading...