Whirlpool TRWP 9801, TRWP 7640 GF, AZA-HP 8772, TRWP 7700, TRWP 9780 User manual

...

CONTENTS

QUICK REFERENCE GUIDE

PROGRAMME CHART

PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING

Please read

instruction for use

INSTRUCTIONS FOR USE

INSTALLATION OF THE DRYER SAFETY ADVICES AND GENERAL

RECOMMENDATIONS ELECTRICAL CONNECTION DESCRIPTION OF THE DRYER MAINTENANCE AND CLEANING THE DOOR FILTER CLEANING THE BOTTOM FILTER DRAINAGE SYSTEM DOOR REVERSIBILITY FAILURE CODES TROUBLESHOOTING GUIDE/

AFTER-SALES SERVICE

Page

5 7 8 8 9 10 11 12

INSTALLATION OF THE DRYER

• The dryer must only be transported in upright position.

• The dryer shall only be transported or lifted by two persons.

• The dryer is exclusively destined to dry dryable laundry in quantities which are usual for private households.

• Observe the instructions given in this instruction for use and the programme chart before using the dryer.

• Keep the instruction for use and the programme chart. If you pass on the dryer to another person, also give him/her the instructions for use and the programme chart.

• The manufacturer declines all liability for damage to property or injury to persons or animals due to noncompliance with the directions given in this instruction for use.

1. Removing the packaging and check

•After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer.

• If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating.

• Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians.

• The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer, in such a way, that a full opening of the tumble dryer door is restricted.

• Small storage rooms located inside, bathrooms, toilets, showers, etc. without ventilation are no suitable places for the installation of the dryer. If it has to be installed here, a good ventilation of the room (open doors, ventilation grid or slot larger than 500 cm²) has to be assured.

• Before running the first cycle, ensure that the water container is fully pushed inside and that the bottom filter is correctly positioned.

2. Electrical Connections

• Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations.

• Electrical connection must comply with local Electricity Board regulations.

• Voltage information, power consumption and the required fuse protection is shown on the rating plate mounted at the rear of the dryer.

• The dryer must be grounded as prescribed by law.

• Before any maintenance on the dryer, disconnect it from the mains supply.

• Mains cable replacement is only to be carried out by After-Sales-Service.

• After installation, access to the mains plug has to be guaranteed or the all-pole disconnection has to be possible with a switch.

• The replacement of the light bulb is only to be carried out by the After-Sales-Service.

3. Installation

•Do not install your dryer where it can be subject to extreme condition, such as: poor ventilation, temperature below 5°C or above 35°C.

• Before running the first cycle, ensure that all hoses of the drainage system are connected (as shown in the picture below).

• If possible, use a hose to drain the water directly into the domestic plumbing system. This will avoid having to empty the water container at the end of each drying cycle since the condensation water can be directly drained away. See also chapter “Drainage System”.

• Take care not to install the dryer on a deep pile carpet.

• Take care not to trap the power cord between the dryer and the wall.

•When installing the dryer always carefully level the dryer adjusting the four feet and check the correct levelling with a level.

• If the dryer has to be installed due to lack of space directly next to a gas or coal stove, a heat insulating plate (85 x 57 cm) has to be installed in between, whose side against the stove has to be covered with aluminium foil.

• A built-in installation is not allowed for the tumble dryer.

• The dryer can be built-under a worktop. A sufficient ventilation of the dryer must be assured. Assemble a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop where the dryer is built under.

C. Insert the distance holders into the holes on both

sides.

D. Fix both distance holders by turning them in

clockwise direction until stop position.

4. Assembly of distance holders

To ensure a correct distance of the appliance from the wall at the rear side and allow a sufficient ventilation, distance holders have to be mounted on the dryer rear side before starting the first drying cycle.

A. Remove the two distance holders from the packaging. B. The distance holders have to be mounted on the

rear side of the dryer in the protection cover.

5. User and child protection

•Children must not be allowed to play with the dryer.

• Ensure that children or small animals can not get into the drum.

• Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.

• The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

Stacking kit

• Depending on the model of your washing machine, your dyer can be stacked on top of your front loading washing machine. For further information please contact the After-Sales-Service.

+ 9 hidden pages