Whirlpool AWZ 412 User Manual

3gb20180.fm Page 1 Tuesday, March 30, 2004 5:59 PM

Programme

selector

knob

1 2 3 4 A B 5 6 7 C D E 8 E

AWZ 412

“Active” indicator light “ON/OFF” Button “Spin Speed Reduction” Button “Rinse Hold” Button “Intensive Rinse” Button “Dryer Half Load” Button Washing “Temperature” Selector Knob

“Drying Time” Selector Knob “Washing Programmes” Selector Knob

Programme Type of load/Notes

Cotton + prewash

Cotton whites

Cotton coloured Average to heavily soiled, hard-wearing cotton or linen fabrics. 5.0 Max. 60° — yes

Rapid

Intensive rinse

Drain / Spin

Synthetics + prewash

Synthetics normal

Delicate normal

Rinse

Special rinse

Drain / Slow spin

Delicate wool

Drain / Slow spin

* drying times for guidance only. These times will be perfected with experience and use.

Heavily soiled, hard-wearing cotton and linen fabrics (bed linen, table linen, underwear, shirts etc.).

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton or linen.

Lightly to normally soiled bed linen, table linen, underwear, towels, shirts etc. made of cotton or linen.

Programme for treating laundry with starch and/or softener. The programme ends with an intensive spin cycle.

Drain, with final spin. Alternative method for unloading laundry earlier.

Heavily soiled shirts, blouses, aprons, etc. made of polyester (diolen, trevira), polyamide (perlon, nylon) or cotton blends.

Lightly to normally soiled blouses, t-shirts, aprons, etc. made of polyester (diolen, trevira), polyamide (perlon, nylon) or cotton blends.

Rinse program, ending with a spin cycle.

Programme for treating laundry with starch and/or softener. The programme ends with an intensive spin cycle.

Drain, with final spin. Alternative method for ending the “Synthetics”, “Delicate” and “Wool” programmes and for unloading the laundry earlier.

Only machine washable woollens with Pure New Wool label.

If you select “Rinse and Hold” do not leave items to soak for too long. Drain, with final spin. Alternative method for ending the “Synthetics”,

“Delicate” and “Wool” programmes and for unloading the laundry earlier.

Avoid touching the glass door during and immediately after running the drying cycle since it will be hot. Do not dry fabrics that have been treated with solvents or petroleum based products, sleeping bags, duvets or bulky clothing. Avoid drying clothing excessively in order to prevent creasing and difficult ironing. For hand-washed items, remove excess water using the highest spin speed before starting the drying cycle.

: option / Yes: add the detergent.

Max. Load

Washing

5.0 Max. 90° yes yes

5.0 Max. 90° — yes

2.5 Max. 40° — yes

5.0 — — —

5.0 — — — — — — — — — — —

2.5 Max. 60° yes yes

2.5 Max. 60° — yes

2.5 Max. 40° — yes

2.5 — — —

2.5 — — — — — — 500 — 1.5 kg 30/40 50

1.0 Max. 40° — yes

1.0 Wool

2.5 Delicate

Washing

temperature

selector

knob

Detergent and Additives

Pre-

Main wash

Fabric

softener

wash

°C

——————— ————

Options Half load

Extra

Rinse

rinse

—

Spin Speed

hold

—

Max.

Drying

Reduction

1200

500

1200

500

1200

500

1200

500

1200

500

500 — 1.5 kg 30/40 50

500 — — — —

Whirlpool is a registered trademark of Whirlpool USA

— 2.5 kg 70/100 120

Approx.

Drying

Load

2.5 kg 70/100 120

1.5 kg 30/40 50

Iron

Dry

Time

5019 301 20180

Approx.

Cupboard

Dry

Time

Black process 45.0° 150.0 LPI

3gb20180.fm Page 2 Tuesday, March 30, 2004 5:59 PM

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx.

Programme Duration

(hours:minutes)

1 - Cotton + prewash 90° 5.0 57 1.85 2:28

2 - Cotton whites 90° 5.0 50 1.07 2:08

3 - Cotton coloured 60° 5.0 53 0.97 2:00

4 - Cotton rapid 40° 2.5 53 0.60 0:40

5 - Synthetics + prewash 60° 2.5 60 0.83 1:15

6 - Synthetics normal 60° 2.5 60 0.83 1:00

7 - Delicate normal 40° 2.5 60 0.42 0:50

8 - Delicate wool 40° 1.0 61 0.32 0:48

The use of the prewash cycle increases programme duration by approximately 15 min. Consumption data was calculated based on normalized conditions in compliance with Standard IEC 60 456. The data on the “Energy Label” refers to programme “Coloured Cotton 60° C”. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

based on the spin speed and type of fabric.

ADD THE DETERGENT, CLOSE THE DOOR AND SELECT THE PROGRAMME

Add the detergent as described in the programme table or in the chapter “Detergent and Additives” in the booklet.

1. Make sure that the .

“Stop”

programme selector

is set to

2. Open the water tap.

3. Set the

programme selector

to the desired

programme.

4. Set the

thermostat knob

to the desired

temperature.

5. Set the

Special options

spin selector knob

can be selected, if required.

to the desired speed.

7. Check that the door is well closed and turn on the

washer-dryer by pressing the

“ON/OFF”

button. The indicator light comes on, indicating that the washer-dryer is on.

SELECT THE DESIRED OPTIONS

“Half load Drying” button (depending on model)

“Extra Rinse” button

(depending on model)

• This option is especially recommended in areas with extremely soft water, for baby linen and linen belonging to skin allergy sufferers.

“Rinse Hold” button

only for synthetic andwool programmes

• The laundry remains in the final rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from running.

• This option is particularly recommended for the programmes “Synthetics” or “Delicate”.

• This function is particularly useful if you want to postpone spinning to a later time or when you do not wish to spin the clothes.

To terminate the “Rinse Hold” option (depending on the model)

synthetic and woolprogrammes only

• Press the Rinse Hold button again; the load will be spun according to the selected programme.

If you do not wish to spin the clothes, turn the programme selector knob to the Drain cycle, after pressing the “No Spin“ button.

“Spin Speed Reduction” button

Reduces or increases the spin speed from 1200 to 500.

The drying times shown may vary

(depending on model)

• The quantity of water duration of the rinse cycle are increased.

DOOR LOCK

The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the

“Stop”

position or if the electricity supply is interrupted, then after approximately two minutes the door is released. In this case do not open the door: because hot water could come out of the door.

CHANGING THE SELECTED PROGRAMME

To change a programme when a cycle has already begun:

1. Switch off the appliance by pressing the “

”button.

ON/OFF

2. Select the new programme.

3. Start the programme by pressing the “

ON/OFF

button.

INTERRUPTING THE CURRENT PROGRAMME

To interrupt the selected programme and continue it at a later time:

1. Press the

“ON/OFF”

button.

2. After the desired interval has passed, press the

“ON/OFF”

button again.

AT THE END OF THE WASH PROGRAMME

1. At the end of the programme the programme selector moves to the

“Stop”

position.

2. To unload the machine wait for the door to release (approx. 2 minutes).

3. Switch off the appliance, open the door and unload the washing.

4. Close the water tap and leave the door ajar to allow the drum to dry out

SETTING THE DRYING CYCLE

1. Load the machine according to the maximum drying load table. The drying function can only be used for cotton and synthetic programmes (not wool) and starts when the knob reaches the programme stop mark. It is important that the laundry has been spun and was washed with water.

When the spin cycle is finished the programme selector moves to

“Stop”

3. Select a drying time based on the type of fabric (cotton/synthetic), amount of laundry and desired final results (iron/cupboard dry), using the “

Drying Time

4. Press the

“Half load Drying”

” knob.

5. Turn on the water tap, check the drain hose, Use the

“ON/OFF”

button to turn on (the

indicator light goes on).

SETTING THE WASHING/DRYING CYCLE IN SEQUENCE

1. The sequential washing and drying function can only be used for energy-saving and synthetic programmes (not wool) and starts when the knob reaches the programme stop mark.

2. Load the washer-dryer (according to the max.

”

drying load table) and close the door

3. Select a drying time based on the type of fabric (cotton/synthetic), amount of laundry and desired final results (iron/cupboard dry), using the “

Drying Time

4. Press the

5. Set the

“Half load Drying”

“Washing Programme”

” knob.

knob to the

desired programme

6. Press the

“ON/OFF”

button to start the

drying cycle.

NOTES AND INDICATIONS FOR USE

CLEANING THE FILTER

•

To ensure smooth operation of the pump, check the filter regularly and clean it when necessary.

Whirlpool is a registered trademark of Whirlpool USA

5019 301 20180

button.

button

Black process 45.0° 150.0 LPI

+ 1 hidden pages