Whirlpool AWT 3389S INSTRUCTION FOR USE

GB
Cotton with prewash
Delicate with prewash
Rinse + Gentle Spin
AWT 3389/S
C
A
Programme
Prew. Cotton
Synthetic with
prewash
Cotton
Cotton Short
Daily Mixed 60’ Slightly to normally soiled textiles made of cotton and/or synthetics.
Synthetic
Synthetic short
Delicate
Wool
Silk
Rinse + Spin
Spin
Gentle spin
Drain
Prew. Synthetic
Prew. Delicate
Cotton
Cotton Short
Synthetic
Synthetic short
Delicate
Wool
Silk
Rinse &
Gentle Spin
Rinse & Spin
Spin
Gentle spin
Drain
Care
Labels
— — — —
Heavily soiled bed linen, table lin en an d un derwear, towels , shirts etc . mad e o f cotton and lin en. Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton. Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear , towels, shirts etc. mad e of cotton and linen. Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Normally soiled overalls and sportswear mad e of cotton, polyester , polyami de and blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and i d en tifi ed as m achin e washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning. Programme for treating delicate laundry with starch or softener. Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed. Programme to spin delicate laundry gently with a restricted spin speed. Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
B
D
Type of wash / Notes
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
A. Programme Selection Knob B. Temperature Selection Knob C. “Spin Speed Selection” Knob D. “On/Off” Button
Max. load
kg
5.0
2.0
1.5
5.0
3.0
3.0
2.0
1.5
1.5
1.0
1.0
2.0
5.0
5.0
2.0
———— ————— — —
: option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care spin speed is restricted to 500 rpm in this programme.
3)
For improved garment care, spin speed is zero in this programme.
Detergents and additives Special Options Tempera-
Prewash Main
1)
Yes
1)
Yes
1)
Yes
— — —
— —
— —
— ——
——
Softener Bleach Rapid Half
Wash
Yes
❉❉❉❉❉❉
Yes
Yes
——— —
Yes
❉❉❉❉❉❉
Yes
——
Yes
———
Yes
Yes
——
Yes
——— —
Yes
——— —
Yes
——— —
——— —
——— —
Intensive
Load
Rinse
Rinse
Hold
❉❉ ❉ ❉
❉❉❉
❉❉
❉❉ ❉ ❉
❉❉❉
ture
Max. 90 800 Max. 60 Max. 40
Max. 90 800 Max. 60 800 Max. 60 800
Max. 60 Max. 60
Max. 40
Max. 40
Max. 30
❉ ❉
°C
———————— — ———————— —
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10193
Max. Spin
Speed
rpm
500 500
500
800
500 500
500
800 800
500
2)
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes) Cotton 90 5.0 63* 1.80 2:05 Cotton 60 5.0 55 0.95 2:05 Cotton 40 5.0 55 0.55 2:05
Daily Mixed 60’ 40 3.0 49 0.48 1:00
Synthetic 60 2.0 56 0.80 1:35 Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temper atur e , som e cold water is added at the end o f th e m ain w ash cycle, before the pump d r ain s the
water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the
“MAX”
level mark, as
follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for sm all loads con sistin g of lightly soiled laundry.
“Half Load” button
• Can be used for small loads and lightly soiled laundry.
• Reduces the water consumption especially during the rinses.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more intensive rinse.
• This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.
• This option is particularly recomm en d ed f or th e “Synthetic”, “Delicate” and “Daily Mixed 60’” programmes.
• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
Note:
the programm e selector kn ob stops on .
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.
• If you do not wish to spin th e clothes , press the
On/Off
” button, turn the programme selector
knob to the “Drain” programme and press the
On/Off
” button again.
PROGRAMME START
Turn on the tap and press the “ The indicator light of the “
On/Off
On/Off
” button.
” button lights
up.
Note
: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop position “ ”.
1. Press the “
On/Off
” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
Open the lid and the drum doors and unload
5.
the machine.
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Switch off the machine by pressing the
On/Off
” button.
2. Select the new programme.
Start programme by pressing the “
3.
On/Off
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the “
On/Off
” button.
2. After the desired pause, press again the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
On/Off
” button.
2. Set the programme selector to “Drain”.
3. Press the “
On/Off
” button again to start the
“Drain” programme.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10193
Loading...