Whirlpool AWE 6317 INSTRUCTION FOR USE
GB AWE 6317 PROGRAMME CHART
A. Programme selector
B. Programme sequence indicator
B
H
C. “Variable spin” button
D. “Start / Pause” button
E. “Reset” button
F. “Door open” indication
I
E
A
D
F
G
C
This washing machine is equipped with
automatic safety functions which detect and
diagnose faults at an early stage and react
appropriately:
G. “Service” indication
H. “Water tap closed” indication
I. “Clean pump” indication
1)
Do not use liquid detergent for main wash if you
have activated prewash option.
2)
For improved garment care, spin speed is restricted
to 400 rpm in this programme.
Programme
Cotton /
Antibacterial
40° - 60° - 95°C
Synthetics
30° - 40° - 60°C
Delicates
30° - 40°C
Daily load 60’
40°C
Quick wash 30’
30°C
Wool
Cold - 40°C
Handwash
30 - 40°C
Rinse & Spin Rinse & Spin
Spin Spin
Gentle spin Gentle spin
Drain Drain
Cotton
40 - 60 - 95 °C
Synthetics
30° - 40° - 60°C
Delicates
30° - 40°C
Daily load 60’
40°C
Quick wash 30’
30°C
Wool
Cold - 40°C
Handwash
30 - 40°C
Care
Labels
—
—
—
——
N.B. This machine is controlled by sensors.
Please avoid excessive detergent dosing.
Max.
load
- For temperature selection, respect the manufacturer’s recommendations on the care label
kg
Normally to heavily soiled bed linen, table linen and underwear , towel s, shirts etc. made of cotton
and linen.
Selecting “Cotton 95”, this programme eliminates bacteria, ensuring sanitization of your laundry.
5.5
The bacteria removal efficiency has been tested following a similar methodology to the NF EN
13697 standard of Nov. 2001.
For washing heavily soiled laundry, the “Prewash” option can be selected.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
2.5
(Perlon, Nylon).
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
1.5
Slightly to normally soiled textiles made of cotton and/or synthetics.
3.0
Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.
3.0
Only woolens, labelled with the Woolmark and identified as machine washable.
This programme (40°C) is approved by The Woolmark Company for the washing of Woolmark
1.0
garments labelled as “machine wash” provided that the garments are washed according to the
instructions on the garment label and those issued in this programme chart.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
This programme (40°C) is approved by The Woolmark Company for the washing of Woolmark
1.0
garments labelled as “hand wash” provided that the garments are washed according to the
instructions on the garment label and those issued in this programme chart.
Same as the last rinse and the final spin in the “Cotton” programme.
5.5
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
5.5
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
1.0
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company
for the washing of Woolmark garments labelled as “machine wash” provided that the garments are
washedaccording to the instructions on the garment label and those issued in this programme chart.
Type of wash / Notes
M0703
Detergents and additives Special Options Max.
Pre-
Main
wash
wash
Yes
Yes
Yes
1)
1)
1)
Yes
Yes
Yes
❉
❉
❉
—
—Yes
—
—
——
Softener Pre-
❉❉❉❉❉❉
❉❉❉❉❉❉
❉❉
❉
❉
❉
❉
❉
Easy
wash
—
—
——
——
Cold
ironing
wash
❉❉ ❉
—
❉❉❉ ❉
❉❉ ❉
—
❉❉ ❉
❉❉ ❉
———
Rinse
Variable
hold
spin
❉❉
———————
———————
Spin
Speed
rpm
800
800
800
800
800
800
400
800
800
❉
800
❉
——————— — —
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10571
2)
CONSUMPTION DATA
Programme
Cotton / Antibacterial
Cotton
**
Temperature
(°C)
95 5.5 55
60 5.5 49 1.02 2:25
Load
(kg)
Water
(l)
*
Energy
Approx. Programme
Duration
(kWh)
(hours : minutes)
1.70 2:00
***
Cotton 40 5.5 53 0.55 2:00
Synthetics 60 2.5 53
0.85 1:30
*
Synthetics 40 2.5 47 0.50 1:15
Delicates 40 1.5 51 0.50 0:45
Daily load 60’ 40 3.0 43 0.48 1:00
Quick wash 30’ 30 3.0 36 0.30 0:30
Wool 40 1.0 53 0.50 0:45
Handwash 40 1.0 43 0.50 0:35
Handwash 30 1.0 42 0.30 0:35
Prewash cycle increases programme duration by approximately 20 min. Consumption values were measured in
normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect
to the values in the table in relation to the water supply pressure and temperature, load and type of wash.
To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump
*
drains the water out.
Reference programme for energy label.
**
PREPARATION OF THE WASH CYCLE
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergent and additives into the dispenser to
no more than the
level mark, as follows:
“MAX”
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Stain remover agents
• Anti-scale agents (if necessary)
3. Close the lid.
4. Turn the
programme selector
programme. The lamp next to the
button flashes.
Pause”
to the desired
“Start/
SELECT THE DESIRED OPTION(S)
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Prewash” button
• Only sensible for heavily soiled loads (for
example sand, granular dirt). The cycle time
increases by approximately 20 min.
“Easy ironing” button
• Can be used together with “Cotton”,
“Synthetics” and “Daily load” programmes to
make ironing easier.
• Increases the water quantity and the clothes are
spun very gently.
“Cold wash” button
• Water is heated only up to 20°C.
• Suitable for delicate laundry items with wash
temperature recommendation of max. 30°C on
the care label.
• Selectable only on the lowest temperature
step of each programme.
“Rinse Hold” button
• The laundry remains in the last rinse water without
progressing to the final spin cycle to avoid creasing
and prevent colours from changing.
• This option is particularly recommended for the
“Synthetics”, “Delicates” and “Daily load”
programmes.
• It is useful if you want to postpone spinning to a
later time, or if you want to drain only.
• If you select “Rinse hold”, do not leave items to
soak for too long.
• As soon as the appliance stops in the rinse hold,
the “Rinse hold” lamp of the programme
sequence indicator lights up and the lamp next to
the
“Start/Pause”
button flashes.
Terminate the “Rinse hold” option:
• Press the
“Start/Pause”
button; the
programme will terminate automatically with the
final spin cycle for the present wash programme.
• If you do not wish to spin the clothes, turn the
programme selector to the “Drain” programme
and press the
“Start/Pause”
button.
“Variable spin” button
• Every programme has an automatically preset
spin speed.
• Press the button to set another spin speed.
If spin speed “0” is selected, the final spin is
•
cancelled and the programme ends with a
drain cycle
.
PROGRAMME START
Turn on the tap and press the
button. The lamp next to the
“Start/Pause”
“Start/Pause”
button lights up. The programme sequence
indicator shows the current programme phase,
running from left to right through Wash, Rinse,
Spin/Drain. When the programme phase is
finished, the corresponding indication goes off.
•
: If there is a power interruption or if the
Note
appliance is disconnected during the cycle, the
programme will run again from the point
where it was interrupted.
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the
lamp lights to show that the lid can be opened. As
long as a wash programme is running, the lid
remains locked and must on no account be forced
open. In case you have an urgent need to open it
during a running programme, refer to “Cancel
(Reset) a running programme before the end”.
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be caused
by a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your Instructions for Use;
if the fault persists, contact our After Sales Service.
“Water tap closed”
The appliance has no or insufficient water supply.
Open the water tap; if the indication still lights up,
refer to the “Troubleshooting Guide” in the
Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether
the drain hose is kinked or the filter must be
cleaned; in the latter case refer to the Instructions
for Use (“Cleaning the Filter”).
PROGRAMME END
All the lights of the programme sequence indicator
are off, and the “Door open” indication lights up.
1. Turn the programme selector to the
“Off/O”
position.
2. Close the water tap.
3. Open lid and drum and unload the machine.
4. Leave the lid open for some time to allow the
interior of the machine to dry.
CHANGE PROGRAMME AND/OR
OPTIONS AFTER PROGRAMME START
1. Press the
“Start/Pause”
button to pause the
programme. The light flashes.
2. Select the new programme, any options and
another spin speed if you want.
3. Press the
“Start/Pause”
button again. The new
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
The
“Reset”
the end. Press the
button cancels a programme before
“Reset”
button for at least 3
seconds. Any existing water is drained out before
the lid can be opened.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10571
Loading...