Whirlpool AKZ 165, AKM 193, BBZH 3000 INSTRUCTION FOR USE
CONTENTS GB
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
OVEN ACCESSORIES
LOWER OVEN FUNCTIONS
TOP OVEN FUNCTIONS
COOLING SYSTEM
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
4
5
6
6
6
7
8
9
9
CLEANING THE OVEN AND ITS ACCESSORIES
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
DECLARATION OF CONFORMITY CE
PAGE
PAGE
PAGE
PAGE
10
11
11
11
3
INSTALLATION
Technical information for the installer
•
After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
•
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure
(see arrow).
•
Check that the appliance has not been
damaged in transit.
•
Oven dimensions and kitchen unit dimensions
are shown in the figure opposite.
•
Kitchen units in contact with the oven must be
heat resistant (80°C min).
If plastic laminates or cement are not
sufficiently heat-resistant, warping, bubbling
or detachment of the finish may result.
•
Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
•
For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm inside
the cabinet).
•
Secure the oven to the kitchen unit (H)
tightening the screws (E) and the selfadhesive plastic spacers (S).Remove the
protection from the self-adhesive side. Before
installation, position the spacers as shown in
the opposite figure.
.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
4
ELECTRICAL CONNECTION
• Important: do not connect to the power
supply before you have finished
connecting the oven and cooktop.
• Warning: Make sure the appliance is
installed and connected to the electricity
supply by a qualified technician in
accordance with the manufacturer’s
instructions and in compliance with local
regulations.
The installer is responsible for the correct
electrical connection of the appliances and the
observance of the relative safety
recommendations.
• The appliance must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact gap
of 3 mm.
The appliances must be earthed by law.
•
Do not use multiple plug adapters or extension
•
leads.
After the oven has been installed, the electrical
•
components must be concealed.
Make sure that the voltage shown on the rating
•
plate is the same as the power supply voltage
in your home. The rating plate is on the front
edge of the oven cavity (visible with oven door
open).
• Attention:
this appliance is 26 A. Connect the appliance
to the mains accordingly.
For Australia only:
The oven is delivered without supply cord.
Use a supply cord type H05 RR-F, 3 X 2,5 mm2
min.
The maximum absorbed power of
5
Loading...