Whirlpool ADS 700 EAS AH INSTRUCTION FOR USE

How to use the appliance

ABC

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

Select, save, and

supply the detergent

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Press the ON / OFF button.

(The first time you use the appliance
and when using a different type of
detergent)

1. Select the third programme from the
top in the relative table.

2. Press the Start button for about 7
seconds until the display changes.

3. Select the required detergent with
the Start button (OFF = powder
detergent, 2 in 1, 3 in 1, 4 in 1) (shown on the display).

4. Switch the appliance off and then switch it on again. The selected
detergent type will be shown on the display for approximately 3
seconds after switching on.

For dosage of powder detergent in compartment A and B refer to the
programmes table.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

Close the dishwasher door,

turn on the water tap

Select a programme

Select additional options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

If necessary (and if provided).
The corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON /
All the indicator lamps switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

Press the START button for 2 sec. until the
Start indicator lamp switches off.

Select another programme and press the
START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.

Dishwasher loading instructions and racks provided

Upper rack:

Fold down glass holder (A):

Depending on the position, for example small or long­stemmed glasses.

Crockery holders (B):

Depending on the position, for example plates, cups
and long-stemmed glasses.

Long-handled utensils (e.g. carving forks, knives)
must be arranged with the sharp end facing in
towards the appliance.

Half Load:

If the upper rack
place the cutlery basket

Rack height adjustment (also when loaded):

Lower adjustment:

Upper adjustment:

is to be loaded,

only

(C)

in the upper rack.

Pull the

outwards and lower

(D)

the rack.
Pull the

upwards until the rack

(D)

clicks into place (factory
setting).

rack handles

two

rack handles

two

The rack must be level on both sides.

Lower rack:

With tilting plate holders

Half load:

Load the lower rack
Greater washing power, particularly for plates and

saucepans.

only

(E)

.

.

Cutlery basket (F):

A grid
items separated.

Cutlery basket

Sharp knives and forks that might cause injury
must be placed in the cutlery basket with the
sharp end facing downwards.

Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for
washing in a dishwasher, for example wooden items, aluminium, tin, hand-decorated crockery
(unglazed), silver cutlery.

can be fitted onto the cutlery basket to keep

(G)

for half loads.

(C)