Whirlpool ADP 9728 BLM, ADP 9728 AVM INSTRUCTION FOR USE
GB
ADP 9728
PROGRAMME CHART
Important:
• If a fault occurs or you wish to change the current programme, p ress the
“START” button for about 5 seconds until the Start indicator lamp switches
off ! Refer to the “Troubleshooting guide” in these user instructions to remedy any problems.
• Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate d uring the first wash cycle.
• Switch off the dishwasher once the “Start” indicator lamp has switched off.
If you switch off the dishwasher during a wash cycle, when switche d on
again the dishwasher resumes the cycle from where it was interrupted.
Départ -Start button indicator lamp:
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs.
Switches “off” at the end of the programme.
Programme selector
Liq Rinç
Lav
Séch
Fin
Programme progress indicators
Pre-rinse
Washing
Drying
Programme end
0 = Off.
Programmes
Rinçage
Délicat 40 °C
Rapide 50 °C
Eco 50 °C * 1)
Quotidien 65 °C
Très Sale 65 °C
Intensif 70°C
Crockery and cutlery
Crockery to be washed later. - - Lightly soiled,
Lightly soiled crockery with no dried-on food. 55 °C - +
Normally or heavily soiled crockery with dried-on food. 65 °C + +
Normally soiled crockery. 65 °C - +
Normally or heavily soiled crockery. 65 °C + +
Heavily soiled pans and saucepans. 65 °C + +
glasses and cups.
Load
Départ
Différé
Rinç
SelLiq Rinç
Fin
SéchLav
Haut Bas
3h 6h 9h
Liq Rinç
Sel
Final rinse
temperature:
Detergent dispenser:
+) with pre-rinse
-) without pre-rinse
** small
compartment
55 °C - +
Rinsing agent
Add rinse aid
Regeneration salt
Add regeneration salt
large
compartment
Water
(Liter)
17.0 1.35 85 14,2 1,28 83
21.0 1.64 93 17,0 1,55 90
3h 6h 9h
Programmes
40°
Délicat
Rinçage
Delay timer
Rapide
65°
50°
50°
Eco
Quotidien
0
65°
Très Sale
70°
Intensif
Starts the dishwasher at the set time: after
3-6-9 hours.
Half load
Load the upper or lower rack only.
Press once = upper rack
Press twice = lower rack
Press 3 times = Off (half load function
deactivated)
Consumption ***
Normal load Half load
Energy
(kWh)
Time
(Min.)
Water
(Liter)
Energy
(kWh)
Départ
Time
(Min.)
*) Recommended programme for use with “new generation” enzyme-based detergents.
**) For pre-rinse.
***) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.
1) Check the programme on the energy data plate.
5019 100 91037
Quick reference guide
Also refer to the "dishwasher loading instructions" which contain detailed information and useful tips.
GB
Daily check list:
1. Turn on the tap.
2. Arrange crockery so that items do not
touch each other.
3. Make sure the water jet can reach all
loaded items and that the spray arms
turn freely.
4. Fill the detergent dispenser and check
the salt and rinse aid levels.
5. Close the dishwasher door.
Tips:
Crockery:
• Load crockery upside down on the
racks.
Cutlery:
• The cutlery basket can be removed
to increase available space.
• Place the cutlery unsorted in the cutlery basket with the handles positioned downwards.
• To avoid the risk of injury on sharp
knives and forks, cutlery can also be
placed in the basket with the handles
positioned upwards.
Cups:
• Load cups at an angle to facilitate water
circulation.
Silver cutlery:
• Always hand wash silver cutlery
immediately after use. Follow the
detergent manufacturer's directions
on the detergent pack.
Important:
• Only load the appliance with
dishwasher-proof crockery and
cooking utensils.
• Certain wooden and aluminium articles may discolour.
• Glued, plastic utensils may be heat
sensitive.
• Tin may become dull.
• Decorated crockery (unglazed) may
fade.
• Glasses may become dull.
Crockery holder:
• Down: cups and long-stemmed
glasses.
• Up: plates.
Half load:
Loading
• Upper rack: the cutlery basketsmay be
• Remove the cutlery baskets from the
the upper rack only.
inserted or removed as required.
lower rack.
Plate holders:
• The plate holders may be removed to
increase available space.
• To remove, pull the handle up.
• To reposition, simply insert in the
required position (normal or crosswise).
Upper rack
Cutlery basket:
Loading the upper rack for a half
load.
Lower rack:
Glass holder:
• The glass holder can be moved sideways.
• Down: short glasses.
• Up: long-stemmed glasses.
Height adjustment:
(The dishwasher
is delivered with the upper rack in the
top position).
The rack height can also be changed
when loaded.
• To lower: pull out the two side handles
and gently lower the rack.
• To raise: pull up the two side handles
until the rack clicks into place.
• The rack must be level on both
sides.
Half load:
Loading
• Greater washing power for plates and
• The cutlery baskets may be inserted
the lower rack only.
saucepans.
or removed as required.
Cutlery basket: the cutlery basket
may be removed to increase available space.
Loading...