Whirlpool ADP 2647 WH INSTRUCTION FOR USE

GB

ADP 2647

Further indications are give n in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.

Quick Reference Guide

Option

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add
regeneration salt immediately before
starting a wash programme.

Programme Symbol

and Temperature

Pre-wash

Rapid 40° C

Bio Eco 50° C

Universal 65° C

Normal 65° C

Intensive 70° C

1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.

2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

3)

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

2)

Normally or heavily soiled crockery with dried-on foo d.

Normally soiled crockery.

Normally or heavily soiled crockery.

Heavily soiled pans and saucepans.

Programme selection and

recommended load type

Place the detergent in the:

small large

compartment compartment

- - 5.0 0.02 9

- X 13.0 0.85 30

X X 16.0 1.26 133

- X 14.0 1.50 73

X X 16.0 1.60 86

X X 22.5 1.75 93

Water

(Litres)

Consumption

Normal load

Energy

(kWh)

5019 100 91273

(We reserve the right to make technical modifications)

1)

Time

(Min.)

A

A

C

C

D

How to use the dishwasher

1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.

2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.

programme indicator lamps will
switch on.

3. Turn the selector knob to select the
desired programme.

corresponding indicator lamp lights

If required, select options

up.

(if supplied).

4. Press the Start button to start the
selected programme.

indicator lamp will light up.

the programmed data cannot be
altered by turning the programme
selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.

To change the programme
selected, press the Start button
for about 5 seconds. The Start
indicator lamp will switch off.
Select a new programme and
press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when
switched on again it will resume the
wash cycle from where it was
interrupted.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from

5. To indicate the end of the programme,

steam.

the Start indicator lamp switches off
and

the End indicator lamp (if fitted)

switches on

(for about 30 min.)

One of the

The

The Start

Once set,

.

6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher.

indicator lamps switch off.

7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.

All the

Upper rack

Please read the user instructions carefully.

Upper and lower rack

Crockery holders:

• Down: cups and long-stemmed
glasses.

•

Up: plates.

Glass holder:

Lower rack

Plate holders:

•(A) May be lowered to increase
available space.

Cutlery basket:

• The cutlery basket can be removed

to increase (C) available space.

• Some models are provided with a
grid (D) that can be fitted onto
the cutlery basket.