Whirlpool ADP 243 S WH INSTRUCTION FOR USE

GB
ADP 243
Further indications are give n in the pages to follow and in the user instructions.
Programme selector
Start button
Indicator lamp lit while the dishwasher is oper ating. Flashes when a fault occurs. Switches off at the end of the programme.
Quick Reference Guide
Programme Symbol
and Temperature
Pre-wash
Bio-Eco 50° C
Universal 65° C
Normal 65° C
1) Values may vary in relation to usage, e.g .: different loads, water temperatures - above or below 15° C ­as well as water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
2)
3)
Crockery to be washed later.
Normally or heavily soiled crockery with dried-on food.
Normally soiled crockery.
Normally soiled crockery, with dried-on food.
recommended load type
Place the detergent in the:
small large
compartment compartment
- - 5.0 0.02 9
X X 20.0 1.40 86
- X 20.0 1.64 87
X X 22.0 1.70 93
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
5019 100 91312
(We reserve the right to make technical modifications)
1)
Time
(Min.)
C
How to use the dishwasher
1. After loading the dishwasher, cl ose the door properly and open the water supply tap.
2. The dishwasher switches on automatically as soon as the programme selector knob is turned.
One of the programme indicator lamps will switch on.
3. Turn the selector knob to select the desired programme.
The corresponding indiator lamp lights up.
(if supplied).
4. Press the Start button to start the selected programme.
indicator lamp will light up.
the programmed data cannot be alte red by turning the programme selector knob.
Note:
pressed, the dishwasher memorises the last programme selected. This information remainsin the memory eve n during interruption of the power supply.
Note:
during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.
5. To indicate the end of the programme, the Start indicator lamp switches off and lights up
If required, select options
The Start
Once set,
once the Start button has been
To change the programme selected, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme and press the Start button.
if the dishwasher is switched off
Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.
the End indicator lamp (if fitted)
(for about 30 min.).
6. Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher.
indicator lamps switch off.
7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.
All the
Upper rack
Crockery holders:
• Down: cups and long-stemmed glasses.
Up: plates.
Glass holder:
Upper and lower rack
Lower rack
C
Cutlery basket (C):
• With or without handle (depending on model).
• The cutlery basket can be removed to increaseavailable sp ace.
Please read the user instructions carefully.
Loading...
+ 2 hidden pages