Remove the consumer Buy Guide Label, tape
and any inside labels (except model and serial
number label) before using the refrigerator.
To remove any remaining glue:
• Rub briskly with thumb to make a ball, then
remove.
OR
• Soak area with liquid hand dishwashing
detergent before removing glue as described
above. Do not use sharp instruments, rubbing
alcohol, flammable fluids or abrasive cleaners.
These can damage the material. See “Important
Safety Instructions" on page 3.
NOTE: Do not remove any permanent instruction
labels inside your refrigerator. Do not remove the
Tech Sheet fastened under the refrigerator at the
front.
Impor ta nt S afe ty In stru cti ons
▲WARNING
• Read ali instructions before using the
refrigerator.
• Chiid entrapment and suffocation are not
problems of the past. Junked or aban
doned refrigerators are still dangerous ...
even if they wiil “just sit in the garage a
few days.”
If you are getting rid of your oid refrigera
tor, do it safely. Please read the enclosed
safety booklet from the Association of
Home Appliance Manufacturers. Help
prevent accidents.
• Never allow children to operate, play with,
or crawl inside the refrigerator.
• Never clean refrigerator parts with flam
mable fluids. The fumes can create a fire
hazard or explosion.
• FOR YOUR SAFETY •
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPORS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY
OTHER APPLIANCE. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
To reduce the risk of fire, electrical shock or injury when using your
refrigerator, foliow basic precautions inciuding the foliowing:
- SAVE THESE INSTRUCTIONS -
It is your responsibility to be sure your
refrigerator:
• is installed and leveled on a floor that will
hold the weight, and in an area suitable for its
size and use.
• is connected only to the proper kind of outlet,
with the correct electrical supply and ground
ing.
• is used only to do what home refrigerators
are designed to do.
• is not near an oven, radiator or other heat
source.
• is properly maintained.
• is out of the weather.
• is used in an area where the room tempera
ture will not fall below 13°C (55°F).
• is not used by anyone unable to operate it
properly.
• is not loaded with food before it has time to
get properly cold.
Befor e Usin g You r R efri ger ato r
Clean it
Clean your refrigerator before using it. See
cleaning instructions on page 11.
Plug it in
Recommended Grounding Method
A 220 or 240 Volt, 50 Hz., AC only 15 or 20
ampere fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance be
provided. Use a receptacle which cannot be
turned off with a switch or pull chain. Do not use
an extension cord.
Install properly
1. Allow 1.25 cm (Vz inch) space on each side
and at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
Leveling screw
Level refrigerator-freezer
1. Remove the base grille. (See page 9.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille. (See page 9.)
Using Y our Ref ri gera tor
Setting the controls
Controls for the refrigerator and freezer are in
the refrigerator. To adjust a control, turn knob.
When the refrigerator is plugged in for the first
REFRIGERATOR
time:
1. Set the refrigerator Control to 4.
2. Set the Freezer Control to C.
Give the refrigerator time to cool down com
pletely before adding food. (This may take
several hours.)
These settings should be right for normal
household refrigerator usage.
The controls will be set about right when milk
or juice is as cold as you like and when ice
cream is firm.
Refrigerator Control adjustments range from
1 to 8. Freezer Control adjustments range from
A to D.
Changing the control settings
If you need to adjust temperatures in refrigerator
or freezer, use the settings listed in the chart
below as a guide.
• Adjust the Refrigerator Control first.
• Wait at least 24 hours between adjustments.
• Then adjust the Freezer Control if needed.
CONDITION:
If Refrigerator
Section is
TOO WARM
If Freezer
Section is
TOO WARM
If Refrigerator
Section is
TOO COLD
If ICE isn'tHeavy ice usage
MADE FAST
ENOUGH
If BOTH
SECTIONS
are TOO WARM
REASON:
Door opened often
Large amount of food added
Room temperature too warm
Door opened often
Large amount of food added
Very cold room temperature
(can’t cycle often enough)
Controls not set correctly
for your conditions
Very cold room temperature
(can’t cycle often enough)
Door opened often
Large amount of food added
Very warm or very cold room
temperatures
RECOMMENDED
CONTROL SETTINGS:
Refrigerator
Freezer
Refrigerator
Freezer
Refrigerator
Freezer
Refrigerator
Freezer
Refrigerator6
FreezerC
6
D
4
A
2
A
4
A
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.