Wharfedale Pro PI-C6, PI-W6, PI-W8, PI-C6ST, PI-C8 Instruction Manual
Specifications
Service Centres
The name ‘WHARFEDALE' is a registered trademark of Wharfedale International Limited.
Wharfedale has a policy of continuous product development and reserves the right to
change specification without notice.
Wharfedale is a member of the International Audio Group.
www.wharfedale.co.uk
USA
IAG America, Inc.
15 Walpole Park South
Walpole
MA 02081
Tel: +1 508 850 3950
CANADA
Korbon Trading Ltd
6800 Kitimat Road
Units 19-20
Mississauga
Ontario
Tel: +1 905 567 1920
UK
Wharfedale International Ltd.
IAG House, Sovereign Court,
Ermine Business Park,
Huntingdon, PE29 6XU,
England.
Tel:+44 (0)1480 447700
Fax: +44 (0)1480 43176
BRITAIN'S MOST FAMOUS LOUDSPEAKERS
Pacific Architectural
Loudspeakers
Instruction Manual
PI-C6
PI-C6ST
PI-C8
PI-W6
PI-W8
Dimensions Overall
H x W x D mm
H x W x D inches
Nominal Impedance
Recommended Amp. Power
Sensitivity (1W@1m)
Frequency Response
Bass Unit
Midrange Unit
Treble Unit
250 mm circular
x 102 mm deep
9.85 (circ) x 4.0
4/6/8 Ohms
5-80 Watts
90 dB
60 - 20 kHz
150 mm kevlar
PI-C6
25 mm textile
250 mm circular
x 111 mm deep
9.85 (circ )x 4.4
2 x 8 Ohms
5 -50 Watts
87 dB
60 - 20 kHz
150 mm kevlar
PI-C6ST
2 x 25 mm textile
288 mm circular
x 128 mm deep
11.3 (circ) x 5.0
4/6/8 Ohms
5 -100 Watts
90 dB
50 - 20 kHz
200 mm kevlar
PI-C8
25 mm textile
332 x 232 x 90
12.2 x 8.8 x 3.5
4/6/8 Ohms
5 -80 Watts
90 dB
50 - 20 kHz
170 mm kevlar
PI-W6
25 mm textile
444 x 284 x 110
17.5 x 11.2 x 4.3
4/6/8 Ohms
5 -100 Watts
90 dB
40 - 20 kHz
200 mm kevlar
50 mm Dome
PI-W8
25 mm textile
Tone Controls
HF ±3dB
LF ± 3dB
HF ±3dB
HF ±3dB
LF ± 3dB
HF ±3dB
LF ± 3dB
HF ±3dB
MF ± 3dB
LF ± 3dB
Securing Method
Clips Clips Clips Clamp Bar
Clamp Bar
Wharfedale speakers are compatible
with 4-8 Ohm amplifiers
Positioning
For stereo and home cinema installations the loudspeakers should be symmetrical to
the main listening area and ideally be sited 2-4 metres apart.
Wall mounting speakers should be installed no more than 5ft (1.5 metres) above the
floor. Rear surround speakers should ideally be on the side walls slightly behind the
listening position. If this position is not available, the rear wall can be used.
Alternatively, ceiling speakers may be considered.
Speakers should be placed at least 400mm (1.4 ft) from the side walls to minimise
colouration. The tweeters on Wharfedale Pacific installed speakers can be rotated for
precise localisation of high frequencies. The illustrations show placement options for
home cinema with the appropriate tweeter adjustments. For combinations of wall and
ceiling speakers, consult the drawings below and on page 8.
The PI-C6ST model is a special case - refer to pages 8 & 9.
REAR L
REAR R
RIGHT
LEFT
CENTRE
2 - 4 metres
RIGHT
LEFT
CENTRE
REAR L
REAR R
2 - 4 metres
CENTRE
3
Dimensions and Cutouts PI-C6, PI-C6ST, PI-C8
105.00
100.00
250.00
Cutout Dimension 205.00 mm (8.07”)circular
PI-C6
115.00
110.00
250.00
Cutout Dimension 205.00 mm (8.07”) circular
PI-C6ST
120.00
115.00
288.00
Cutout Dimension 245.00 mm (9.8”) circular
PI-C8
10
CEILING MOUNTING
PI-C6, PI-C8
WALL MOUNTING
PI-W6, PI-W8
HOME CINEMA INSTALLATION USING WALL AND CEILING UNITS
Loading...