This drawing shows the location(s) of the warning
decal(s). If a decal is missing or illegible, see
the front cover of this manual and request a
free replacement decal. Apply the decal in the
location shown. Note: The decal(s) may not be
shown at actual size.
WESLO is a registered trademark of ICON IP, Inc.
2
IMPORTANT PRECAUTIONS
WARNING: T
instructions in this manual and all warnings on your exercise bike before using your exercise bike.
ICON assumes no responsibility for personal injury or property damage sustained by or through the
use of this product.
1. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or persons with pre-existing health problems.
2. Use the exercise bike only as described in
this manual.
3. It is the responsibility of the owner to ensure
that all users of the exercise bike are adequately informed of all precautions.
4. The exercise bike is intended for home use
only. Do not use the exercise bike in a commercial, rental, or institutional setting.
5. Keep the exercise bike indoors, away from
moisture and dust. Do not put the exercise
bike in a garage or covered patio or near
water.
6. Place the exercise bike on a level surface
with at least 2 ft. (0.6 m) of clearance around
the exercise bike. To protect the floor or
carpet from damage, place a mat under the
exercise bike.
o reduce the risk of serious injury, read all important precautions and
8. Keep children under age 12 and pets away
from the exercise bike at all times.
9. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the exercise bike. Always wear
athletic shoes for foot protection.
10. The exercise bike should not be used by
persons weighing more than 250 lbs.
(113 kg).
11. The heart rate monitor is not a medical
device. Various factors, including the user's
movement, may affect the accuracy of heart
rate readings. The heart rate monitor is
intended only as an exercise aid in determining heart rate trends in general.
12. The exercise bike does not have a free
wheel; the pedals will continue to move until
the flywheel stops. Reduce your pedaling
speed in a controlled way.
13. Always keep your back straight while using
the exercise bike; do not arch your back.
7. Inspect and properly tighten all parts regularly. Replace any worn parts immediately.
14. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop immediately and
cool down.
3
BEFORE YOU BEGIN
Thank you for selecting the new WESLO®PURSUIT
CT 1.5 exercise bike. Cycling is an effective exercise
for increasing cardiovascular fitness, building
endurance, and toning the body. The PURSUIT CT 1.5
exercise bike provides a selection of features
esigned to make your workouts at home more effec-
d
tive and enjoyable.
For your benefit, read this manual carefully before
you use the exercise bike. If you have questions
Length: 2 ft. 9 in. (84 cm)
Width: 1 ft. 8 in. (51 cm)
Weight: 66 lbs. (30 kg)
after reading this manual, please see the front cover
of this manual. To help us assist you, note the product
model number and serial number before contacting
us. The model number and the location of the serial
number decal are shown on the front cover of this
anual.
m
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Handlebar
Console
Heart Rate Monitor
Seat
Seat Post Knob
Leveling Cap
Resistance Knob
Water Bottle Holder*
Pedal/Strap
*Water bottle is not included
4
ASSEMBLY
M8 Split
Washer (50)–3
M8 Locknut
(10)–6
M4 x 15mm
Screw (48)–6
M8 x 15mm Patch
Screw (34)–3
M10 x 70mm Patch Screw (33)–2
M8 x 60mm Patch Screw (30)–4M8 x 65mm Bolt (49)–2
To hire an authorized service technician to assemble the exercise bike, call 1-800-445-2480.
ssembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
A
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver, an adjustable
wrench, and pliers.
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
5
1.
To make assembly easier, read the
nformation on page 5 before you begin.
i
nsert the Rear Stabilizer (6) into the Frame (1).
I
Attach the Rear Stabilizer with four M8 x 60mm
Patch Screws (30).
1
1
6
30
2. See the inset drawing. Remove the screw and
the cardboard tube from the Frame (1). Discard
the screw and the cardboard tube.
Orient the Front Stabilizer (2) so that the large
holes face the Frame (1).
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 70mm Patch Screws (33).
2
Screw
33
Large
Holes
Cardboard
Tube
2
1
1
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.