Welch Allyn Connex Vital Signs Monitor Installation Guide

Welch Allyn Connex®
Vital Signs Monitor

Quick Reference Card

Power on/Standby

• Powers up the monitor

• Brief press – Sets monitor to Display power saving mode

Battery status

Charging

Approximate operating time remaining

Battery removed or not holding a charge

Input clinician ID with barcode scanner

1. Touch the Clinician ID section (left edge) of the Device Status area.

2. Scan the clinician ID with a barcode scanner.
The ID appears in the field.

3. Touch OK.

Input patient ID with barcode scanner

1. Touch the Home tab.

2. Scan the patient’s ID with a barcode scanner.
The ID appears in the field.

Reset (pause or turn off) audio alarms

Touch .

Adjust alarm limits

Touch or in the alarming parameter to display alarm controls. Adjust a limit or turn off.

Start/Stop blood pressure

Start automatic intervals

1. Properly size the blood pressure cuff and position

it around the patient’s bare upper arm.

2. On the Home tab, touch

3. Select Automatic.

4. Use the numeric keypad to enter the length of
time between NIBP measurements.

5. Touch Start intervals.

.