Weed Eater 952711940 User Manual

R Trademark

Please do not return product to retailer. Por favor, no devuelva el producto al lugar de compra. Veuillez ne pas retourner le produit au détaillant.

1--800--554--6723

www.weedeater.com

Instruction Manual

Manual de Instrucciones

Manuel d’Instructions

SST25C

ENGLISH ESPAÑOL

For Occasional Use Only

WARNING:

Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.

ADVERTENCIA:

Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves.

AVERTISSEMENT:

Lire le manuel d’instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves.

WEED EATER 7349 Statesville Road Charlotte, NC 28269

850 Matheson Blvd. West

Mississauga, Ontario L5V 0B4

545186797 Rev. 5 3/1/10 BRW

WEED EATER

FRANÇAIS

IDENTIFICATION OF SAFETY SYMBOLS

DANGER: Use only specified trimmer head,

spool, and 0.095 in ch (2.4 mm) recommended trimmer line. Never use blades, flailing devices, wire, rope, string, etc. Unit is designed for line trimmer use only. Failure to follow these instructions may result in serious injury.

WARNING: This unit can be dangerous! Careless or improper

use can cause serious injury.

WARNING: Read the operator’s manual before use. Failure to

follow instructions could result in serious injury to the operator and/or bystanders. Save operator’s manual.

Hazard zone for thrown objects.

S Trimmer line throws objects violently. S You and others can be blinded/injured. S Keep children, bystanders, and animals

50 feet (15 meters) away.

Trimmer line can throw objects violently. You can be blinded or injured. Always wear hearing protection and safety glasses marked Z87. Always wear heavy, long pants, long sleeves, boots and gloves.

Secure hair above shoulder length. Do not wear jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc. They can be caught in moving parts.

Never allow children to operate this unit.

IDENTIFICATION OF SAFETY SYMBOLS

Store unit indoors in a high, dry place out of the reach of children.

When servicing unit, use only identical replacement parts.

Always stop unit and disconnect spark plug before cleaning or servicing.

WARNING: Fire hazard. Never mix, pour, or store gasoline or

use the unit near a flame or sparks (including smoking, open flames, or work that can cause sparks).

Use unleaded gasoline and two--stroke oil mixed at a ratio of 40:1 (2.5%).

SAFETY RULES

WARNING: When using gardening

appliances, basic safety precautions must always be followed to reduce the risk of fire and serious injury. Read and follow all instructions.

This power unit can be dangerous! Operator is responsible for following instructions and warnings on unit and in manual. Read entire instruction manual before using unit! Be thoroughly familiar with the controls and the proper use of the unit. Restrict the use of this unit to persons who have read, understand, and will follow the instructions and warnings on the unit and in the manual. Never allow children to operate this unit.

INSTRUCTION MANUAL

SAFETY INFORMATION

ON THE UNIT

DANGER: Never use blades or flailing

devices. This unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury. If situations occur which are not covered in this manual, use care and good judgment. If you need assistance, contact your authorized service dealer or call 1-800-554--6723.

OPERATOR SAFETY

S Dress properly. Always wear safety glasses

or similar eye protection when operating, or performing maintenance, on your unit (safety glasses are available). Eye protection should be marked Z87.

S Always wear face or dust mask if operation is

dusty.

S Always wear heavy, long pants, long sleeves,

boots, and gloves. Wearing safety leg guards is recommended.

S Always wear foot protection. Do not go bare-

foot or wear sandals. Stay clear of spinning line.

S Secure hair above shoulder length. Secure or

remove loose clothing or clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.

S Being fully covered also helps protect you

from debris and pieces of toxic plants thrown by spinning line.

S Stay Alert. Do not operate this unit when you

are tired, ill, upset or under the influence of alcohol, drugs, or medication. Watch what you are doing; use common sense.

S Wear hearing protection. S Never start or run inside a closed room or

building. Breathing exhaust fumes can kill.

S Keep handles free of oil and fuel.

UNIT / MAINTENANCE SAFETY

WARNING: Disconnect the spark

plug before performing maintenance except carburetor adjustments. S Look for and replace damaged or loose parts

before each use. Look for and repair fuel leaks before use. Keep in good working condition.

S Replace trimmer head parts that are chipped,

cracked, broken, or damaged in any other way before using the unit.

S Maintain unit according to recommended pro-

cedures. Keep cutting line at proper length.

S Use only 0.095 inch (2.4 mm) diameter

WEED EATER brand line. Never use wire, rope, string, etc.

S Install required shield properly before using

the unit. Use only specified trimmer head; make sure it is properly installed and securely fastened.

S Make sure unit is assembled correctl y as

shown in this manual.

S Make carburetor adjustments with lower end

supported to prevent line from contacting any object.

S Keep others away when making carburetor

adjustments.

S Use only recommended WEED EATER ac-

cessories and replacement parts.

S Have all maintenance and service not ex -

plained in this manual performed by an authorized service dealer.

FUEL SAFETY

S Mix and pour fuel outdoors. S Keep away from sparks or flames. S Use a container approved for fuel. S Do not smoke or allow smoking near fuel or

the unit.

S Avoid spilling fuel or oil. Wipe up all fuel spills. S Move at least 10 feet (3 meters) away from

fueling site before starting engine.

S Stop engine and allow to cool before remov-

ing fuel cap.

S Always store gasoline in a container ap-

proved for flammable liquids.

CUTTING SAFETY

WARNING: Inspect the area before

each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury.

S Keep others including children, animals,

bystanders, and helpers at least 50 feet (15 meters) away. Bystanders should be encouraged to wear safety glasses. Stop engine immediately if you are approached.

S Use only for trimming, scalping, mowing and

sweeping. Do not use for edging, pruning or hedge trimming.

S Keep firm footing and balance. Do not over-

reach.

S Keep all parts of your body away from muffler

and spinning line. Keep engine below waist level. A hot muffler can cause serious burns.

S Cut from your right to your left. Cutting on left

side of the shield will throw debris away from the operator.

S Use only in daylight or good artificial light. S Use only for jobs explained in this manual.

TRANSPORTING AND STORAGE

S Allow engine to cool; secure unit before stor-

ing or transporting in vehicle.

S Empty the fuel tank before storing or trans-

porting the unit. Use up fuel left in the carburetor by starting the engine and letting it run until it stops.

S Store unit and fuel in area where fuel vapors

cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

S Store unit so line limiter blade cannot acciden-

tally cause injury. The unit can be hung by the shaft.

S Store unit out of reach of children.

SAFETY NOTICE: Exposure to vibrations

through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti--vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.

SPECIAL NOTICE: This unit is equipped

with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion engines be equipped with a spark arresting screen. If you operate in a locale where such regulations exist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arresting screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your authorized service dealer.

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is properly assembled and all fasteners are secure. Examine parts for damage. Do not use damaged parts.

NOTE: If you need assistance or find parts

missing or damaged, call 1-800-554-6723. It is normal for the fuel filter to rattle in the empty fuel tank. Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

SHAFT ASSEMBLY CAUTION:

the unit on a flat surface for stability.

1. Align grooves on upper and lower shafts.

Lower Shaft

2. Push the two shafts together until the lower shaft is fully seated in the upper shaft (the shafts lock into place).

When assembling shaft, place

Upper Shaft

Grooves

NOTE: If locking sleeve assembly will not

tighten, the shafts are not fully seated.

ADJUSTING THE HANDLE

WARNING: When adjusting the assist

handle, be sure it remains above the safety label and below the mark or arrow on the shaft.

1. Loosen wing nut on handle.

2. Rotate the handle on the shaft to an upright position; retighten wing nut.

ATTACHING SHIEL D

WARNING: The shield must be prop-

erly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.

1. Remove wing nut from shield.

2. Insert bracket into slot as shown.

3. Pivot shield until bolt passes through hole in bracket.

4. Securely tighten wing nut onto bolt.

Shield

Bracket

3. Slide lower lockingsleeve assembly over upper locking sleeve assembly and tighten by turning clockwise.

Upper Locking Sleeve Assembly

Lower Locking Sleeve Assembly

Slot

Wing Nut

+ 9 hidden pages