Waldorf GP8910E, GPL8910E, GPL8910EC, GPB8910E, GP8910EC Installation And Operation Manual

Installation and Operation Manual

GP8910E
GP8910EC

Electric Griddle Ranges

Date Purchased

Serial Number

Dealer

Service Provider

230379-8

For use in GB & IE

GPL8910E
GPL8910EC

GPB8910E
GPB8910EC

GPLB8910E
GPLB8910EC

The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in
writing by the manufacturer.

In line with policy to continually develop and improve its products, Moffat Ltd. reserves the right to change the specifications and
design without prior notice.

© Copyright Moffat Ltd. November 2014.

MANUFACTURED BY

Moffat Limited

Rolleston 7675
New Zealand

INTERNATIONAL CONTACTS

AUSTRALIA

Moffat Pty Limited
Web: www.moffat.com.au
E.Mail: [e-mail]
Main Office: (tel) [phone]

(fax) [phone]

Service: (tel): 1800 622 216
Spares: (tel): 1800 337 963
Customer Service: (tel): 1800 335 315
(fax): 1800 350 281

CANADA

Serve Canada
Web: www.servecanada.com
E.Mail: [e-mail]
Sales: (tel): 800 551 8795 (Toll Free)
Service: (tel): 800 263 1455 (Toll Free)

NEW ZEALAND

Moffat Limited
Web: www.moffat.co.nz
E.Mail: [e-mail]
Main Office: (tel): 0800 663328

UNITED KINGDOM

Blue Seal
Web: www.blue-seal.co.uk
E.Mail: [e-mail]
Sales: (tel): [phone]

(fax): [phone]
Spares: (tel): [phone]
(fax): [phone]
Service: (tel): [phone]
(fax): [phone]

UNITED STATES

Moffat
Web: www.moffat.com
Sales: (tel): 800 551 8795 (Toll Free)

(tel): [phone]
(fax): [phone]
Service: (tel): 800 858 4477 (Toll Free)
(tel): [phone]
(fax): [phone]

REST OF WORLD

Moffat Limited
Web: www.moffat.co.nz
E.Mail: [e-mail]

Contents

Waldorf Electric Griddle

GP(L)(B)8910E Electric Griddle Range, Static Oven 900mm.
GP(L)(B)8910EC Electric Griddle Range, Convection Oven 900mm.

Introduction ............................................................................................. 2

Specifications ........................................................................................... 3

Model Numbers Covered in this Specification

General

Electrical Supply Requirements

Electrical Connection

Dimensions

Installation ................................................................................................ 5

Installation Requirements

Unpacking

Location

Clearances

Assembly

Electrical Connection

Commissioning

Operation ................................................................................................... 8

Operation Guide

Description of Controls

Griddle

Oven

Cleaning and Maintenance ...................................................................... 10

General

After Each Use

Daily Cleaning

Weekly Cleaning

Periodic Maintenance

Fault Finding ............................................................................................ 13

Circuit Schematics ................................................................................... 14

Replacement Parts List ........................................................................... 17

2

Introduction

We are confident that you will be delighted with your WALDORF Electric Griddle Range, Static / Convection
Ovens and they will become a most valued appliance in your commercial kitchen.
To ensure you receive the utmost benefit from your new WALDORF appliance, there are two important
things you can do.

Firstly:

Please read the instruction book carefully and follow the directions given. The time taken will be well
spent.

Secondly:

If you are unsure of any aspect of the installation, instructions or performance of your appliance,
contact your WALDORF dealer promptly. In many cases a phone call could answer your question.

CE Only:

These instructions are only valid if the country code appears on the appliance. If the code does not
appear on the appliance, refer to the supplier of this appliance to obtain the technical instructions for
adapting the appliance to the conditions for use in that country.

WARNING:

I

MPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY
DAMAGE, INJURY OR DEATH. READ THE INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
THOROUGHLY BEFORE INSTALLING OR SERVICING THIS APPLIANCE.

WARNING:

G

REAT CARE MUST BE TAKEN BY THE OPERATOR TO USE THE EQUIPMENT SAFELY TO GUARD IT AGAINST RISK

OF FIRE.

 T

HE APPLIANCE MUST NOT BE LEFT ON UNATTENDED.

 I

T IS RECOMMENDED THAT A REGULAR INSPECTION IS MADE BY A COMPETENT SERVICEMAN TO ENSURE

CORRECT AND SAFE OPERATION OF YOUR APPLIANCE IS MAINTAINED.

 DO NOT

STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS OR LIQUIDS IN THE VICINITY OF

THIS OR ANY OTHER APPLIANCE.



DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.

C

AUTION

:

This appliance is;



For professional use and is to be used by suitably qualified / trained
persons only.



Only authorised service persons are to carry out installation, servicing and
gas conversion operations.



Components having adjustments protected (e.g. paint sealed) by the
manufacturer should not be adjusted by the user / operator.



DO NOT operate the appliance without the legs supplied fitted.

3

Specifications

Model Numbers Covered in this Specification

GP[1]8910E Electric Griddle Range, Static Oven 900 mm wide.
GP[1]8910EC Electric Griddle Range, Convection Oven 900 mm wide.

NOTE:

[1]: - Model Options;

- - Standard.
L - Low Back.
B - Bold Front.
LB - Low Back and Bold Front.

General

A commercial heavy duty, 900mm wide, Electric Griddle Range, designed for modular kitchens and
constructed in an easy clean stainless steel external finish. The griddle elements are constructed
using stainless steel sheathed heating elements with dual thermostatic control zones.

The Griddle uses a 20mm thick griddle plate with the option of either ribbed or chromed mirror plate
options.

The range can be equipped with either an electric 6.5kW convection or static oven, 900mm wide.

Electrical Supply Requirements

Electrical Connection

Electrical supply connection point is located at the rear of the appliance, approximately 80 mm from
the right hand side and 467 mm from the rear and 150 mm from the floor.

When connecting a Waldorf electric appliance to the main supply, ensure that the following is carried
out:-

 An isolating switch is fitted within 2 m of the appliance, but not on the appliance and in

such a position that the user does not have to reach across the cooking surface.

 Supply cord shall be oil-resistant, sheathed flexible cable and not lighter than ordinary pol-

ychloroprene or other equivalent synthetic elastomer sheathed cord (as per AS / NZS 3191
part 2.10.11. or IEC 60245-IEC-57) e.g. H05 RN-F Type.

 The branch supply line shall be individually overload protected to the correct current rating

and the supply chord shall be protected against any mechanical or thermal damage.

 A grommet is fitted around the wiring entry hole into the appliance.

 All wiring connections must be tight.

Refer to the appropriate wiring standards for the size of cable that is to be supplied to an appliance
for the current drawn on that line.

MODEL

Fan Motor

GP8910E 18.5 kW

L1 - 24.6 Amps
L2 - 25.6 Amps
L3 - 25.6 Amps

---------

GP8910EC 18.9 kW

L1 - 25.9 Amps
L2 - 25.6 Amps
L3 - 25.6 Amps

100W

3-Phase Connection

3P+N+E

400-415V, 50/60Hz

WARNING:

THIS APPLIANCE MUST BE EARTHED. IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY A SUITABLY

QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.

4

Dimensions

GP(L)8910E / EC

5

Installation Requirements

NOTE:

 It is most important that this appliance is installed correctly and that operation is correct

before use. Installation shall comply with local electrical and health and safety
requirements.

 This appliance shall be installed with sufficient ventilation to prevent the occurrence of

unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.

Waldorf Electric Griddle Ranges Electric Static / Convection Oven are designed to provide years of
satisfactory service and correct installation is essential to achieve the best performance, efficiency and
trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical, fire and health and safety.

Australia / New Zealand AS / NZS3000 - Wiring Rules.
United Kingdom: BS 7671 - Requirements for Electrical Installations.

Installations must be carried out by authorised persons only. Failure to install equipment to
the relevant codes and manufacturer’s specifications shown in this section will void the
warranty.

Components having adjustments protected (e.g. paint sealed) by the manufacturer are only
to be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.

Unpacking

 Remove all packaging and transit protection from the appliance including all protective plastic

coating from the exterior stainless steel panels.

 Check equipment and parts for damage. Report any damage immediately to the carrier and

distributor.

 Ensure that the adjustable feet / castors are securely fitted.

 Report any deficiencies to the distributor who supplied the appliance.

 Check that the available electrical supply is correct to that shown on the rating plate (Refer to the

dimension drawings for rating plate location).

Location

1. Installation must include adequate clearance and ventilation, to prevent dangerous build up of
combustion products.

2. Never directly connect a ventilation system to the appliance flue outlet.

3. Position the appliance in its approximate working position.

4. The legs / castors must always be fitted to the base of the appliance.

5. Components having adjustments protected (e.g. paint sealed) by the manufacturer are only to be
adjusted by an authorised service agent. They are not to be adjusted by the installation person.

NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to

the appliance flue outlet.

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.

Installation

Combustible Surface Non Combustible Surface

Left / Right Hand Side 250 mm 0 mm

Rear 50 mm 0 mm