VTECH® Power Zone™ 2000 ACTIVITIES: .......................... 38
CARE AND MAINTENANCE ...................... 39
45
CAUTION-ELECTRIC TOY
FOR
TOY TRANSFORMER
- Not recommended for children under 3 years
of age. As with all electrical products, precautions should be observed during handling and
use to reduce the risk of electric shock.
Input: AC120V 60 HZ 9W
Output: DC 14.5V 4.5 VA
- The adaptor should be periodically examined
for conditions that may result in the risk of fire,
electric shock, or injury to persons (such as
damage to the output cord, blades, housing, or
other parts). In the event of such conditions, the
transformer should not be used until properly
repaired.
46
INTRODUCTION
Thank you for purchasing the VTECH® Power Zone™ 2000 learning product! We
at VTECH® are committed to providing the highest quality products to entertain
and educate your children. Should you have any questions or concerns, please
call our Consumer Services Department at 1-800-521-2010 in the U.S. or 1-800267-7377 in Canada.
The VTECH® Power Zone™ 2000 is an electronic learning aid. This unit offers
a wide range of exciting and educational activities for interactive learning! The
unit’s 77 built-in activities and computer skills tools to encourage learning in an
entertaining and effective manner.
LCD
VOLUME
SWITCH
LED
LENS
CONTRAST
SWITCH
CARTRIDGE
DOOR
AC ADAPTOR
CA TEGOR Y
BUTTON
TYPING
KEYBOARD
MOUSE P AD
1
ON BUTTON
OFF BUTTON
CARTRIDGE
MOUSE
PREPARATION
MOUSE CONNECTION
1. Make sure the unit is turned OFF.
2. Locate the mouse jack on the back of the keyboard.
3. Plug the mouse into the unit’s mouse jack.
4. Turn the unit ON.
PRINTER CONNECTION
1. Make sure both the VTECH® Power Zone™ 2000 learning aid and the printer
are turned OFF.
2. Locate the printer port on the right side of the VTECH® Power Zone™ 2000
learning aid.
3. Connect the printer plug to the printer port.
4. Turn ON the VTECH® Power Zone™ 2000 learning aid and the printer.
Please refer to Printer Setup for the list of printers that the VTECH® Power
Zone™ 2000 learning aid supports.
POWER SOURCE
The VTECH® Power Zone™ 2000 learning aid can be operated by using 4 “C”
size batteries or a 14.5V 4.5VA center-positive adaptor.
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the unit and open it.
3. Insert 4 "C" batteries as illustrated.
DO NOT USE RECHARGEABLE
BATTERIES in this unit.
4. Close the battery cover.
2
KEYBOARD BATTERY INSTALLATION
1. Locate the battery cover on the bottom of the
keyboard and open it.
2. Insert 4 "AA" batteries as illustrated.
DO NOT USE RECHARGEABLE BATTERIES in
the keyboard.
3. Close the battery cover.
BATTERY NOTICE
•Install batteries correctly observing the polarity (+ , _) signs to avoid leakage.
•Do not mix old and new batteries.
•Do not use batteries of different types together.
•Remove exhausted or new batteries from the unit when you are not going
to use the unit for a long time.
•Do not dispose of the batteries in fire.
•Do not attempt to recharge ordinary batteries.
•Do not short-circuit supply terminals.
BACKUP BATTERY INSTALLATION
•Make sure the unit is OFF.
•Locate the backup battery cover on the bottom
of the unit and open it.
•Insert 1 CR2025 battery as illustrated.
•Replace the battery cover.
•Turn the unit ON.
•Remove the plastic strip from the backup battery. (During the first time
installation only) To avoid damage to the unit from leaky batteries, replace
the backup battery at least once a year.
NOTE: While replacing the backup battery, the 4 “C” size batteries must be kept
in the unit or the unit must be connected to the 9V adaptor while the
adaptor is plugged in. If not, you will lose all the information stored in
activities such as:
• Word Processor• Money Manager
• Calendar• Telephone Book
• Scheduler• Data Pairs 1
• Test Trainer 1• LOGO
In addition to these activities, newly setup players' names and scores will also be lost.
3
NOTE: If the unit suddenly stops working or the sound becomes weak, turn the
unit OFF for 15 seconds, then turn it back ON. If the problem persists,
it may be caused by weak batteries. Please install a new set of batteries
and try the unit again.
AC ADAPTOR CONNECTION
Use a 14.5V 4.5VA center-positive adaptor.
1. Make sure the unit is OFF.
2. Locate the adaptor jack on the back of the unit.
3. Plug the adaptor into the unit’s adaptor jack.
4. Plug the adaptor into a wall outlet.
5. Turn the unit ON.
NOTE: Do not leave the adaptor plugged in for long periods of time if the unit
is not in use.
ON
OFF
ON/OFF BUTTON
Turn ON your VTECH® Power Zone™ 2000 learning aid by pressing
the ON button on the front panel. The unit will show an opening animation
and you can select a category or an activity. Turn the unit OFF by
pressing the OFF button on the front panel.
RESET BUTTON
If the ON button is unable to turn on the unit or if the unit suddenly stops working,
press RESET button on the bottom of the unit to restart.
AUTOMATIC SHUT-OFF
If there is no input into the VTECH® Power Zone™ 2000 learning product for
several minutes, the unit will automatically shut off to save power. After the
automatic shut-off is activated, you need to press the ON button again. We
recommend that you turn the unit OFF when not playing with it. If the VTECHPower Zone™ 2000 learning product is not going to be used for a long period,
remove the batteries and unplug the adaptor.
VOLUME SWITCH
Adjust the volume by sliding the Volume Switch up to raise the
volume and down to lower the volume.
®
4
CONTRAST SWITCH
Adjust the image on the screen by sliding the Contrast Switch
up for higher contrast and down for lower contrast.
MOUSE, KEYBOARD AND CURSOR
CONTROL
MOUSE
To use the mouse, push it in the direction that you would like the pointeron
the screen to move. To move the pointer to the right side of the screen, push
the mouse to the right. To move the pointer to the left side of the screen, push
the mouse to the left. To move the pointer to the top of the screen, push the
mouse away from you. To move the pointer to the bottom of the screen, pull
the mouse towards you. In most activities, pressing the left mouse button will
have the same effect as pressing the Enter key.
Left mouse
button
Right mouse
button
®
Mouse door
CLEANING THE MOUSE
To clean the mouse, you need to open the
cover on the bottom of the mouse by using
a screwdriver. Twisting in the direction of the
arrows will release the cover. Once the cover
is removed, the mouse ball should be taken
out and the contents inside the mouse should
be cleaned with a dry cloth. The mouse ball
should also be cleaned with a dry cloth.
Once you have finished cleaning the mouse,
place the mouse ball back into the mouse,
place the cover back on the mouse and screw
the cover back onto the mouse.
5
KEYBOARD
X
Print
Screen
Answer
£
%
$
5
4
REW
T
D
F
G
V
C
Space
Ctrl
&
^
6
7
UY
J
H
NM
B
*
8
I
KL
(
9
O
<
Alt
)
0
P
>
Repeat
{
[
?
PG UP
PG DNHOME
}
]
Backspace
Del
Ins
Enter
Shift
Right
Player
END
Break
Esc
Tab
Caps Lock
Shift
Left
Player
Help
!
1
Q
A
Symbol
Level
3
2
S
Z
Quick
Tag
Player
#
@
The VTECH® Power Zone™ 2000 learning aid has a full alphanumeric keyboard
with 65 keys.
Key labels
Some keys have two different functions. These keys are activated when choosing
various activities. Please refer to the description of activities to learn about the
dual-function keys.
SPECIAL KEYS
In addition to the alphanumeric keys, there are some special function keys:
Break
Esc
Escape Key:
The Esc key allows you to exit the current activity. By repeatedly
pressing the Esc key you can go back to the main menu.
Break
Esc
Left
Player
Help
Break Key:
Press the Shift key and Break key simultaneously when you
want to interrupt a program in LOGO while it is running.
Help Key:
When you are not sure about the answer, press the Help key.
Help will give you hints and at the same time, you will lose
a chance to answer a question. Press this key to receive hints
in some of the activities. In activities like Synonyms or
Antonyms, Help will show one of the letters in the answers
as a hint. The Help key has slight variations among different
activities, so for detailed usage, please refer to the description
of the activities.
6
Caps Lock
Right
Player
PG UP
HOME
PG DN
END
Caps Lock Key:
Press this key to make letters you type appear in capitals
without having to press the Shift key each time. Press once
to activate this key. Press it again to release it.
Repeat
Print
Screen
Answer
NOTE: In the 2-player mode the Answer key cannot be used during the first
player’s turn.
Enter
Quick
Tag
Player
Symbol
Level
Press this key to repeat the instructions and the question (the
unit will repeat the question if the question on the screen is
only partially visible.)
Answer Key:
Press this key to find the correct answer to a question. You
will not receive points if this key is pressed.
Enter Key:
Press this key after typing each answer so the unit registers
your input.
Player Key:
Press this key to select the 1-player or 2-player mode in the
activities that have a 2-player mode.
Level Key:
Press this key to select a level of difficulty in some of the
activities. There are four levels with the first level being the
easiest and the fourth level being the most difficult. Levels
can be changed at any time during an activity.
Repeat Key:
Symbol
Level
Symbol Key:
Press the Shift key and the Symbol key together to see a symbol
menu that contains several pages of symbols. Press the
keys to select a symbol. Then press the Enter key or the left mouse
button to confirm the selection.
7
Loading...
+ 32 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.