
2
INTRODUCTION
Thank you for purchasing the VTech® Pop-a-Balls™ Push & Pop
BulldozerTM. The bulldozer comes to life when the colorful balls are
dropped into the cab of the bulldozer. Load the balls and push the
bulldozer to see the balls pop up through the smoke stack, into the
scoop bucket and back again.
Light-Up Driver
Button
On/Off/Volume
Control Switch
Smoke Stack
Tire Gear
Number
Buttons

3
INCLUDED IN THIS PACKAGE
• One Push & Pop BulldozerTM • Four balls
• One handle • Two large plugs
• Four small screws
• One parent’s guide
WARNING:
All packing materials, such as tape, plastic
sheets, packaging locks, removable tags, cable
ties and packaging screws are not part of this toy,
and should be discarded for your child’s safety.
ATTENTION:
Pour la sécurité de votre enfant, débarrassez-
vous de tous les produits d’emballage tels que
rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE:
Please keep this parent’s guide as it contains
important information.

4
Unlock the packaging locks:
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the bulldozer. Use a screwdriver to loosen
the screw.
3. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
Rotate the packaging locks 90 degrees
counter-clockwise.
Pull out the packaging locks.