VTech pop-a-balls, Drop & Pop BallPit User Manual

™

US

91-003378-000

Parent’s Guide

Drop & Pop Ball Pit

TM

506200 IM.indd 1 04/19/2017 17:32:00

2

2

INTRODUCTION

Thank you for purchasing the VTech® Pop-a-Balls™ Drop & Pop Ball
Pit™. Your little one will love playing in the ball pit, tossing the balls in

the hoop and counting to ten with fun sounds. Press the orange button
to hear more fun sounds and responses as the balls pop!

Collapsible
Ball Pit

Ball Hoop

Bird

On/Off Mode

Switch

Volume Control

Switch

Electronic

Activity Panel

Activity

Panel

Base

30 Balls

506200 IM.indd 2 04/19/2017 17:32:02

3

3

INCLUDED IN THIS PACKAGE

• One activity panel base • One electronic activity panel

• One attachment clip • One collapsible ball pit

• Two small screws

• 30 balls

• One parent’s guide

WARNING:

All packing materials, such as tape, plastic
sheets, packaging locks, removable tags, cable
ties and packaging screws are not part of this toy,
and should be discarded for your child’s safety.

ATTENTION:

Pour la sécurité de votre enfant, débarrassez-

vous de tous les produits d’emballage tels que
rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas
partie du jouet.

NOTE:

Please keep this parent’s guide as it contains
important information.

506200 IM.indd 3 04/19/2017 17:32:04

4

4

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.

2. Locate the battery cover on the
back of the unit. Use a coin or a
screwdriver to loosen the screw.

3. Install 3 new AA (AM-3/LR6)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)

4. Replace the battery cover and tighten
the screw to secure.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.

• Use only batteries of the same or equivalent type as recommended.

• Do not mix different types of batteries: alkaline, standard (carbon-

zinc) or rechargeable, or new and used batteries.

• Do not use damaged batteries.

• Insert batteries with the correct polarity.

• Do not short-circuit the battery terminals.

• Remove exhausted batteries from the toy.

• Remove batteries during long periods of non-use.

• Do not dispose of batteries in fire.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy before charging (if

removable).

• Rechargeable batteries are only to be charged under adult

supervision.

506200 IM.indd 4 04/19/2017 17:32:04

5

5

ASSEMBLY INSTRUCTIONS

With the Drop & Pop Ball Pit™, safety comes first. To ensure your child’s

safety, adult assembly is required.

WARNING! This unit contains small screws. For your child’s

safety, do not let your child play with the toy until it is fully
assembled. Adult supervision is recommended.

1. Insert the Electronic Activity Panel to the
Activity Panel Base. Using a screwdriver,

insert the two small screws into the screw
holes on the back of the Activity Panel
Base.

2. Place the Activity Panel Base in the
ball pit. Insert the two blue Attachment
Straps into the slots on the bottom of
the Activity Panel Base, then pull on
the straps until the loops pull through
the slots. Hook the two blue straps on
either side of the Activity Panel Base.

3. Slide the Activity Panel against the
fabric wall. Locate the two slots on the
back of the activity panel and fasten it
to the fabric wall using the Attachment
Clip. You will hear the Attachment Clip
snap into place when inserted correctly.

506200 IM.indd 5 04/19/2017 17:32:06