VTech IP8100-2/81003 User Manual
IMPORTANT SAFETY INSTRUCTIONS .......................................................... 1
Parts Check List................................................................................................3
The Handset Layout .........................................................................................4
The Base Unit Layout ....................................................................................... 5
GETTING ST ARTED......................................................................................... 6
SETUP ..............................................................................................................6
Connecting power to Base Unit/Handset Charger .......................................... 6
Installation of Battery Pack in Handset.............................................................6
Charging of the Handset Battery Pack ............................................................. 6
Reset Switch..................................................................................................... 7
Checking for Dial Tone.....................................................................................7
Wall Mounting ................................................................................................... 8
Installation Without A Router ............................................................................ 9
Installation With A Router ............................................................................... 1 1
BASIC OPERATION ....................................................................................... 12
Handset and Base Indicators ......................................................................... 1 2
Handset Icons.................................................................................................12
Handset LEDs ................................................................................................ 1 2
Base LEDs...................................................................................................... 1 2
Handset Operation .........................................................................................13
Making Calls ................................................................................................... 13
Answering Calls .............................................................................................13
Adjust the Handset Volume............................................................................13
Flash Function ................................................................................................1 3
Redial Function .............................................................................................. 13
Dial Vonage Voicemail ...................................................................................14
Mute Function ................................................................................................. 1 4
Intercom Call .................................................................................................. 14
Call Forward ................................................................................................... 1 5
Conference Call .............................................................................................15
Base Operation ...............................................................................................1 5
Phonebook Operation ....................................................................................16
Storing a New Entry........................................................................................16
Reviewing/Dialing from the Phonebook ........................................................17
Editing a Phonebook entry .............................................................................1 8
Delete a phonebook entry.............................................................................. 1 8
Calls Log (Caller ID - Call Waiting) ................................................................ 1 9
Caller ID - Call Waiting ID ..............................................................................1 9
Reviewing Caller ID .......................................................................................19
Storing a Caller ID ..........................................................................................2 0
Dialing from Caller ID ..................................................................................... 2 0
Deleting Caller ID ........................................................................................... 21
Handset Settings ............................................................................................2 2
Ringer Volume ............................................................................................... 22
Ringer Tone .................................................................................................... 22
Table Of Contents
Key Tone (preset to ON)................................................................................. 22
Language (preset to English).........................................................................23
Message Waiting ............................................................................................2 3
Clear Message waiting ................................................................................... 2 3
ADVANCED OPERATION ............................................................................. 2 4
Headset Operation .........................................................................................24
ADDITIONAL INFORMA TION ........................................................................25
In Case Of Difficulty ........................................................................................ 25
Maintenance................................................................................................... 26
Warranty Statement ........................................................................................ 2 7
FCC and IC Regulations ................................................................................3 0
Technical Specifications ................................................................................32
Table Of Contents
1
Important Safety Instructions
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including
the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the power outlet and broadband connection before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen
sink, or swimming pool).
5. Do not place this product on an unstable cart, stand, or table. The product
may fall, causing serious damage.
6. Slots and openings on the base and handset are provided for ventilation. To
protect it from overheating, these openings must not be blocked by placing
the product on the bed, sofa, rug, or other similar surface. This product
should never be placed near or over a radiator or heat register. This product
should not be placed in a built-in installation where proper ventilation is not
provided.
7. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power supply
to your home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it.
9. Never push objects of any kind into this product through the slots in the base
or handset as they may touch dangerous voltage points or short out parts
that could result in a risk of fire or electric shock. Never spill liquid of any kind
on the product.
10.To reduce the risk of electric shock, do not disassemble this product, but
take it to an authorized service facility. Opening or removing cabinet parts
other than specified access doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause electric shock when the
appliance is subsequently used.
11.Do not overload wall outlets and extension cords as this can result in the risk
of fire or electric shock.
12. Unplug this product from the wall outlet and contact VTech under the following
conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating in structions, because improper adjustment of other controls may
result in damage and will often require extensive work to restore the
product to normal operation.
2
Important Safety Instructions
BEFORE USING YOUR IP 8100-2/8100-3 SYSTEM, CAREFULLY PEEL OFF
THE PROTECTIVE FILM COVERING THE DISPLAYS.
E. If the product has been dropped and the handset and/or base unit has
been damaged.
F. If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than cordless) during an electrical storm.
There may be a remote risk of electric shock from lightning.
14.Do not use this or any cordless telephone to report a gas leak in the vicinity
of the leak.
15. Use only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode. Check with local codes for
possible special disposal instructions.
SAVE THESE INSTRUCTIONS
3
Parts Check List
NOTE: USE ONLY VTech Battery 80-5808-00-00 or VTech Replacement
89-1324-00-00.
6. Charger Wall Mounting Bracket
7. Belt Clips
8. User Documentation CD
9. Quick Start Guide
10.Batteries
1. Base Unit
2. Handsets
3. Handset Chargers
4. Ethernet Cable
5. Base Power Adapter
The IP 8100-2/8100-3 is an advanced Broadband cordless telephone set, capable of supporting four handsets.
This manual is designed to familiarize you with this Broadband cordless telephone. We strongly recommend you read the manual before using your phone.
Base Unit
Handset
Base AC Adapter
Handset Charger
Ethernet Cable
Belt Clip
User Docu-
mentation CD
Quick Start Guide
Charger Wall Mounting
Bracket
Battery
NOTE: If you have purchased the IP 8100-3, please also refer to the parts list
in your IP 811 User’s Manual.
4
1. Antenna
2. Earpiece
3. Volume Control
4. CID (Scroll Down)
5. On (Flash)
6. Voicemail
7. Dialing Keys (0-9, *, #)
8. Redial (Pause)
The Handset Layout
9. Speakerphone
10. LCD Display
11.Select (Menu)
12. Phonebook (Scroll Up)
13.Headset Jack (2.5mm)
14.Off (Clear)
15.Intercom
16.Mute (Delete)
16
12
13
5
The Base Unit Layout
2
3
5
6
7
8
1
4
1. Message Waiting LED
2. Page key
3. In Use LED
4. Service Status LED
5. LAN Port
6. WAN Port
7. DC Connector Jack
8. Reset Switch
6
Getting Started
Setup
Charging of the Handset Battery Pack
The handset of your cordless telephone is powered by a rechargeable battery
pack. It charges automatically whenever handset is in its charger.
Y ou should char ge the batteries for 10-12 hours when y ou first receive your
phone. You will know the battery pack needs charg-
ing when:
• The low battery message is displayed:
• The handset seems completely dead, the LCD
is completely clear and does not activate when
you press the keys.
NOTE: While in PLACE IN CHARGER (low battery) mode, the keypad sounds,
backlighting and speakerphone features will not work. When the battery has
been charged, the features will return to their normal function.
IMPORTANT:
1. Do not dispose of the battery pack in a fire, it might explode.
2. Do not open or mutilate the battery pack. Toxic substances may be released, causing harm to eyes or skin.
3. Exercise care in handling batteries in order to prevent an accidental short of
the charge contacts, potentially causing the batteries to overheat.
Installation of Battery Pack in Handset
Follow the steps below:
1. Remove the battery compartment
cover by pressing on the indentation
and sliding downward. Place the new
battery pack in the handset with the
positive and negative poles aligned
in the battery compartment.
2. Replace the battery cover by sliding
it upwards.
3. If the new battery pack is not already
charged, place the handset in its
charger, and allow it to charge for
10-12 hours. After initial charge, a
maintenance charge of 8 hours
should be sufficient.
Connecting power to Base Unit/Handset Charger
1. Plug the power adapter into an electrical outlet, and the connector into the
connector jack at the bottom of the base
unit.
2. Choose the location for your handset
charger, and plug its power supply into an
electrical outlet.
7
Getting Started
Setup
IMPORTANT! MAXIMUM PERFOR-
MANCE OF YOUR CORDLESS TELEPHONE SYSTEM:
1. Install your base unit and extension
handsets away from electronic equipment, such as personal computers,
television sets and microwave ovens.
2. In locations where there are multiple
cordless telephones, separate the
base units as far away as possible.
3. Install your telephone equipment
away from heat sources and sunlight.
4. Avoid excessive moisture, dust or extreme cold.
CAUTION: Use only the VTech power supply provided with your telephone.
4. Do not dispose of the battery pack into household garbage. Please refer to
the information concerning proper battery recycling.
5. Do not charge the battery pack with other electrical devices.
Reset Switch
The reset switch, when quickly pressed and released, will reset the phone and
restart the software. Beware that when the reset switch is pressed and held for
> 10 seconds and then released, the phone will restore to factory defaults. This
includes clearing and resetting the password on the web configuration.
Reset switch does not affect your base unit power, RF operation, or any of the
telephone handset settings.
Checking for Dial Tone
After the battery is charged, press ON on the handset. The LCD displays PHONE
and shows a call timer, and you will hear a dial tone. If not, see In Case of
Difficulty.
Add new handsets to make your phone more versatile
Your telephone can accommodate up to four cordless handsets. You can add
new handsets (Model IP 811, sold separately) at any time. You can register a
maximum of four handsets.
8
Getting Started
W all Mounting
The wall mount brackets are designed for use on standard wall mount plates
only. Wall mounting is optional. Only the handset chargers (not the main base
unit) can be wall mounted.
1. Plug the power adapters into electrical outlets, and the connector to the bottom
of the handset charger.
2. Line up the tabs on the wall mount brackets with the holes at the back of the
handset charger. Snap the wall mount bracket firmly in place.
3. Mount the handset charger on the wall. Position the handset charger so th e
mounting studs will fit into the holes on the wall mount bracket. Slide handset charger down on the mounting studs until it locks into place.
Loading...