Vortex Optics RIDGEVIEW TRIPOD KIT User Manual

VORTEX RIDGEVIEW TRIPOD

Congratulations on your purchase of the rugged, compact Vortex Ridgeview tripod.

Ball Head with Quick Release Plate

Using the ball head lever

The ball head lever controls all movement of the head. Release the tension by turning the lever (F) counter-clockwise—this allows you to move the head freely in all directions. Turn the lever clockwise to increase the tension again.

Use the quick release (QR) plate to attach a spotting scope, binocular, or camera to the Ridgeview tripod.

1. Release the quick release plate by loosening the tension lock knob (B) and

sliding the quick release plate (C) forward until it reaches the pin lock.

2. Push the pin lock (E) in and slide the quick release plate off the

plate platform (D).

3. Thread the quick release plate onto the body of the spotting scope,

binocular, or camera and tighten the screw so the connection is secure.

4. Reattach the quick release plate by pushing the pin lock in and sliding the

plate back on until it is centered on the plate platform.

5. Secure the quick release plate in place by tightening the tension lock knob.

1. 2. 3. 4. 5.

A. Ball Head B. QR Plate Tension Lock Knob C. QR Plate D. QR Plate Platform E. QR Pin Lock F. Ball Head Lever G. Center Column Locking Collar H. Compass I. Tripod Bubble Level J. Variable Leg Release Button K. Center Column L. Accessory Hook M. Flip-Lever Leg Lock

©Vortex Optics USA 2009

Extending the leg length

Each tripod leg has four sections with padding on two of the upper leg

sections. To extend a leg, release the flip-lever

locks (M) and slide leg sections out to the desired length. Press the flip-lever back down to lock a section in place.

Wrench set included.

Adjusting the variable leg angle spread

Adjust the tripod leg angles for ease of use in various

scenarios. Pull the leg

release button (J) and lift the leg upward to one of two different angle positions. Repeat with

Legs can be adjusted for a low-angle viewing position.

other legs as needed.

Adjusting the center column

Change the position of the center column (K) to gain additional height. Unlock the center column by rotating the collar (G) in a counter-clockwise direction. Maneuver the center column to the desired height and lock in place by rotating the collar in a clockwise direction.

Stabilize the tripod in windy conditions by hanging a counterweight

(not supplied) from the center column accessory hook (L).

Using the level

Use the leveling bubble (I) to gauge your alignment and allow for optimum viewing and photography. The tripod will be level when the bubble is within the black circle.

Warranty and Service

This product is warranted to be free of defects in materials and workmanship for three years after purchase. Vortex Optics will repair or replace such product or part thereof that, upon our inspection, is found to be defective in materials or workmanship.

If you need assistance using your tripod, please contact:

Vortex Optics

2120 West Greenview Drive

Middleton, WI 53562

800-426-0048

service@vortexoptics.com