VIZIO SS2521-C6 Quick Start Guide
VIZIO
QUICK START GUIDE
Model: SS2521-C6
IMPORTANT SAFETY INSTRUCTIONS
Your Unit is designed and manufactured to operate within dened design limits, and misuse may result in electric shock or re. To prevent
your Unit from being damaged, the following rules should be observed for its installation, use, and maintenance. Please read the following
safety instructions before operating your Unit. Keep these instructions in a safe place for future reference.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliers) that produce
heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the
other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your
safety. If the provided plug does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
• Only use attachments/accessories specied by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the apparatus. When a
cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as when
the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
• To reduce the risk of electric shock or component damage, switch o the power before connecting other components to your Unit.
• Unplug the power cord before cleaning your Unit. A damp cloth is sucient for cleaning. Do not use a liquid or a spray cleaner on your
Unit. Do not use abrasive cleaners.
• Always use the accessories recommended by the manufacturer to insure compatibility.
• When moving your Unit from an area of low temperature to an area of high temperature, condensation may form in the housing. Wait
before turning on your Unit to avoid causing re, electric shock, or component damage.
• Slots and openings in the back and bottom of the cabinet are provided for ventilation. To ensure reliable operation of your Unit and to
protect it from overheating, be sure these openings are not blocked or covered. Do not place your Unit in a bookcase or cabinet unless
proper ventilation is provided.
• Never push any object into the slots and openings on your Unit enclosure. Do not place any objects on the top of your Unit. Doing so
could short circuit parts causing a re or electric shock. Never spill liquids on your Unit.
• When connected to a power outlet, power is always owing into your Unit. To totally disconnect power, unplug the power cord.
• Do not overload power strips and extension cords. Overloading can result in re or
electric shock.
• The wall socket should be located near your Unit and be easily accessible
• Keep your Unit away from moisture. Do not expose your Unit to rain or moisture. If water penetrates into your Unit, unplug the power
cord and contact your dealer. Continuous use in this case may result in re or electric shock.
• Do not use your Unit if any abnormality occurs. If any smoke or odor becomes apparent, unplug the power cord and contact your
dealer immediately. Do not try to repair your
unit yourself.
• Avoid using dropped or damaged appliances. If your Unit is dropped and the housing is damaged, the internal components may
function abnormally. Unplug the power cord immediately and contact your dealer for repair. Continued use of your Unit may cause
re or electric shock.
• Do not install your Unit in an area with heavy dust or high humidity. Operating your Unit in environments with heavy dust or high
humidity may cause re or electric shock.
• Ensure that the power cord and any other cables are unplugged before moving your Unit.
• When unplugging your Unit, hold the power plug, not the cord. Pulling on the power cord may damage the wires inside the cord and
cause re or electric shock. When your Unit will not be used for an extended period of time, unplug the power cord.
• To reduce risk of electric shock, do not touch the connector with wet hands.
• Insert the remote control batteries in accordance with instructions. Incorrect polarity may cause the battery to leak which can damage
the remote control or injure the operator.
• See the important note and rating located on the back of the unit.
• WARNING - This equipment is not waterproof. To prevent a re or shock hazard, do not place any container lled with liquid near the
equipment (such as a vase or ower pot) or expose it to dripping, splashing, rain, or moisture.
• CAUTION - Danger of explosion or re if batteries are mistreated. Replace only with the same or specied type.
• Do not leave the batteries exposed to direct sunlight for a long period of time with doors and windows closed. Do not disassemble
the batteries or dispose of it in re.
• Where the MAINS plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture.
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
Explanation of WARNING symbols:
The lighting ash with arrowhead symbol within an equilateral triangle is intended to
alert the user to the presence of not isolated dangerous voltage within the product
that may be sucient magnitude to constitute a risk of shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and servicing instructions in the literature
accompanying the appliance.
Warning: This equipment is a Class II or double insulated electrical appliance. It has
been designed in such a way that it does not require a safety connection to electrical
earth.
TABLE OF CONTENTS
Package Contents ................................................................... 4
Controls & Connections ......................................................... 5
First-Time Setup...................................................................... 8
Using the Remote ................................................................... 14
LED Indicators ......................................................................... 15
Bluetooth Pairing .................................................................... 16
Using Bluetooth Mode ........................................................... 17
Advanced Setup ...................................................................... 18
Using Button Combinations .................................................. 19
Help & Troubleshooting ......................................................... 25
One-Year Limited Warranty ................................................... 26
Legal & Compliance ................................................................ 27
PACKAGE CONTENTS
2.1 Sound Stand
Remote Control with
2 x AAA Batteries
2 x Quick Start Guides
(1 English, 1 French/Spanish)
Power Cable
4
Stereo RCA to 3.5mm
Audio Cable
Coaxial Audio
Cable
Digital Optical
Cable
CONTROLS & CONNECTIONS
Front of Sound Stand
LED Indicators
12 LED indicators will give visual feedback when
you press buttons on the remote control.
5
Back of Sound Stand
AUX (1)
Analog Audio In
Service*/USB Port
Service Port/USB In
AUX (2)
Analog Audio In
Power Port
DIGITAL (3)
Coaxial In
OPTICAL (4)
Digital Optical Audio In
6
Side of Sound Stand
Power
Input
Bluetooth Input
(Hold to force pair, See
Bluetooth Pairing
Volume + / -
for more information)
7
FIRST-TIME SETUP
1
Important: The Sound Stand is designed to hold TVs
up to 55” in size with a weight of up to 60lbs. The TV
base should not be larger than 12.5” by 14”.
Place the Sound Stand on a at, stable level surface.
VIZIO recommends that you rst place your TV alongside the
Sound Stand so that the connection ports are easy to access.
8
2
Back of Sound Stand
GOOD
3.5MM TO
RCA CABLE
GOOD
3.5MM TO
RCA CABLE
AND CONNECT IT TO YOUR TV
Note: Not all TVs have the audio outputs shown above. To connect the Sound Stand directly to your
other devices (Blu-ray player, game system, etc) see your device’s user manual.
BETTER BETTER
DIGITAL OPTICAL
CABLE*
CHOOSE ONE CABLE:
BETTERGOOD
* When using either of the Digital Inputs, if there is no audio: (A) try setting the TV output to PCM or (B)
Connect directly to your Blu-ray/other source, some TVs do not pass through digital audio.
9
DIGITAL COAXIAL
CABLE*
Loading...